luminii LETO-21 Double Single Senso Light Instruction Manual
- June 1, 2024
- luminii
Table of Contents
LETO 21 Double
Overview
-
Mounting Surface
Please make sure the mounting surface is strong enough to hold at least 0.88lb (0.4kg). -
Ceiling Thickness
Ceiling thickness must be between 1/4″ & 1″ (6mm & 25mm). If the thickness of the ceiling is thinner than 1/4″ (6mm), use an #6-32 screw to set fixture in place. -
Ceiling Cutout
9.25″ x 4.75″ cutout is required.
Read and follow these instructions before installing or
maintaining this product
- This product is suitable for DRY INDOOR LOCATIONS ONLY
- Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
- Allow air to flow freely around the fixture
- Do not switch on line voltage until all wiring is complete
- Incorrect wiring will result in irreparable damage to LED and power supply
- This product should only be installed by a licensed electrician
Warranty
- This product must be installed in accordance with all applicable installation codes and ordinance
- Limited five (5) years warranty
- Warranty is void in the eventuality of unauthorized modifications and/or improper use
- Plaster Frame
- IC Housing
Install appropriate housing between ceiling joists. Connect the driver to the line voltage and ground to enclosure.
Install ceiling. Make sure hole is cut to appropriate size and location.
9.25″ x 4.75″
Insert Spackle trim and secure in place with #6 drywall screws.
Mud over trim and finish ceiling installation.
Ensure power is off. Lower quick connect wire from ceiling and connect to
fixture until you hear a click.
Insert fixture assembly into spackle trim. Secure in place at each corner with
screws
Screw magnets in place on the fixture brackets.
Raise trim plate up until it is held in place by magnets.
Adjust head to desired angle.
Rev November 22, 2023 
403-216-7043 |
info@sensolighting.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>