luminii BLC-XX LED Strip Light Instruction Manual
- May 15, 2024
- luminii
Table of Contents
luminii BLC-XX LED Strip Light
Installation Instructions
Please read all instructions prior to installation and keep for future reference!
- PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
- USE ONLY WITH CLASS 2 POWER UNIT.
- 24 VOLTS DC.
- SUITABLE FOR DAMP LOCATIONS.
- SURFACE MOUNT ONLY
- SUITABLE FOR INSTALLATION WITHIN THE CLOSET STORAGE SPACE.
- INHERENTLY PROTECTED
Note: Complete fixture must be built prior to installing. To make all necessary reference marks & to also ensure all parts are included. Then it can be taken apart for installation.
- Snap lens into the extrusion, then align & center the extrusion to the determined location. Make all necessary markings to install to the surface. Prior to installation of extrusion, 24VDC power must be present.
Caution: Safety equipment is recommended, when modifications are being made to the extrusion & lens.
- If necessary extrusion, lens, & mounting channel (if applicable) can be cut in the field. Snap all parts together then using the proper blade for aluminum cut to the desired length.
Note: Extrusion are not waterproof. If it is going to be installed facing up and in a wet location, drainage holes should be drilled along the inner corner of the extrusion every 12”. Drill 1/16” to 1/8” diameters holes before installing LED strip
-
Line LED can be shortened by cutting along the dashed lines in between the solder pads. Make sure the cut is made on the side of the Line LED without the wire leads. Line LED cannot touch the metal endcap which will shorten the circuit.
-
Prior to installing Line LED to extrusion, clean extrusion from any debris. Gently push Line LED onto aluminum extrusion. Then install endcaps at each ends of the extrusion.
-
Remove the protective film from the diffuser lens. Snap the diffuser lens into the aluminum extrusion.
-
Screw mounting brackets into previously made markings from step 1, then clip the extrusion on to the mounting brackets.
-
Snap the fixture into the installed mounting brackets.
Note: To remove the extrusion from the mounting brackets, carefully insert a flat screwdriver to the bottom edge of the extrusion then pull up until the extrusion pops up. -
Screw mounting brackets into previously made markings from step 1, then clip the extrusion on to the mounting brackets.
Note: To remove the extrusion from the mounting brackets, carefully insert a flat screwdriver to the bottom edge of the extrusion then pull up until the extrusion pops up.
-
Rotate the fixture to the desired angle.
-
Ensure the correct (wattage & voltage) power supply is used to power Line LED. Then proceed to connect Line LED wires from extrusion to power supply. For more information please refer to power supply and Line LED wiring instructions.
CUSTOMER SUPPORT
7777 Merrimac Ave Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>