luminii PS-UNI-PR-96-24 Pure DC Universal Power Supply Installation Guide

May 15, 2024
luminii

Pure DC® Universal Power Supplyluminii PS UNI PR 96 24 Pure DC
Universal Power Supply REV0.3
01182024
1/2
Installation Instructions
Model: PS-UNI-PR-96-24

PS-UNI-PR-96-24 Pure DC Universal Power Supply

Please read all instructions prior to installation and keep for future reference!
This LED Driver is to be installed in accordance with Article 450 of the National Electrical Code. The LED Driver must be installed in a well ventilated area and free from explosive gases and vapors. Proper operation requires the free flow of air as this LED Driver is hardwired, it should only be installed by a qualified electrician. Suitable For Pool and Spa Rated Locations. Installation must also comply with provisions of the National Electric Code, ANSI/NFPA 70, including those in Article 680 – Swimming Pools, Fountains, and Similar Installations.

MODELS PS-UNI-PR-96-24
MAX Load 96 watts
A. Length 8.71”
B. Width 4.56”
C. Depth 1.86”
Net Weight 3.5 lbs

Before installing, check the label and ensure the LED Driver has the proper input voltage, output voltage, and wattage for the job. Check the wire markings to ensure they match the wiring diagram below. Refer to table above for the maximum loads!![luminii PS UNI PR 96 24 Pure DC Universal Power Supply

  • maximum](https://manuals.plus/wp-content/uploads/2024/03/luminii-PS-UNI- PR-96-24-Pure-DC-Universal-Power-Supply-maximum.jpg)1.1 With a minimum of 2” clearance around power supply to provide proper air circulation. luminii PS
UNI PR 96 24 Pure DC Universal Power Supply - maximum 11.2 Power supply must be placed 5 feet horizontally away from the inside walls of the pool unless separated from the pool by a solid fence, wall, or other permanent barrier.luminii PS UNI PR 96 24 Pure DC
Universal Power Supply - maximum 22.1 Remove the two Phillips screws from the top of the driver housing and pull the cover off to expose the driver wires.luminii PS
UNI PR 96 24 Pure DC Universal Power Supply - maximum 33.1 Insert the 120-277 VAC power into the driver housing from the electrical panel. Followed by bringing the 24V DC low voltage wires from the LEDs into the driver housing. In addition bring the controller wire if applicable. Refer to diagram on page 2 to make all the proper wiring connecitons. 4.1 Make sure that all knockouts and openings are properly sealed or closed with acceptable plugs. luminii PS UNI PR 96 24 Pure DC Universal
Power Supply - maximum 5luminii PS UNI PR 96 24 Pure DC Universal Power Supply -
maximum 65.1 Insert the wire nut connections in the driver housing using waterproof wire nuts and close housing cover. Secure by tightening the two screws.
    *LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals