luminii B45C-XX Max Horizontal Flexible LED Strip Installation Guide

May 15, 2024
luminii

B45C – Installation Instructions
Models B45C-XX

B45C-XX Max Horizontal Flexible LED Strip

Please read all instructions prior to installation and keep for future reference!

  1. PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
  2. USE ONLY WITH CLASS 2 POWER UNIT.
  3. 24 VOLTS DC.
  4. SUITABLE FOR DAMP LOCATIONS.
  5. SURFACE MOUNT ONLY
  6. SUITABLE FOR INSTALLATION WITHIN THE CLOSET STORAGE SPACE.
  7. INHERENTLY PROTECTED

luminii B45C XX Max Horizontal Flexible LED Strip - Figure
1 Note: Complete fixture must be built prior to installing. To make all necessary reference marks & to also ensure all parts are included. Then it can be taken apart for installation.
1.1 Snap lens into the extrusion, then align & center the extrusion to the determined location. Make all necessary markings to install to the surface. Prior to installation of extrusion, 24VDC power must be present.luminii
B45C XX Max Horizontal Flexible LED Strip - Figure 2 Caution: Safety equipment is recommended, when modifications are being made to the extrusion & lens.
2.1 If necessary extrusion, lens, & mounting channel (if applicable) can be cut in the field. Snap all parts together then using the proper blade for aluminum cut to the desired length.luminii B45C XX Max Horizontal Flexible
LED Strip - Figure 3 Note: Extrusion are not waterproof. If it is going to be installed facing up and in a wet location, drainage holes should be drilled along the inner corner of the extrusion every 12”. Drill 1/16” to 1/8” diameters holes before installing LED strip
3.1 LineLED can be shortened by cutting along the dashed lines in between the solder pads. Make sure the cut is made on the side of the LineLED without the wire leads. LineLED cannot touch the metal endcap which will shorten the circuit.luminii B45C XX Max Horizontal Flexible LED Strip - Figure
44.1 Prior to installing LineLED to extrusion, clean extrusion from any debris. Gently push LineLED onto aluminum extrusion. Then install endcaps at each ends of the extrusion.luminii B45C
XX Max Horizontal Flexible LED Strip - Figure 55.1 Remove the protective film from the diffuser lens. Snap the diffuser lens into the aluminum extrusion.luminii B45C XX Max Horizontal
Flexible LED Strip - Figure 66.1 Screw mounting brackets into previously made markings from step 1, then clip the extrusion on to the mounting brackets.luminii B45C XX Max Horizontal
Flexible LED Strip - Figure 77.1 Snap the fixture into the installed mounting brackets.
Note: To remove the extrusion from the mounting brackets, carefully insert a flat screwdriver to the bottom edge of the extrusion then pull up until the extrusion pops up.luminii B45C XX Max Horizontal Flexible LED
Strip - Figure 88.1 Ensure the correct (wattage & voltage) power supply is used to power LineLED.
Then proceed to connect LineLED wires from extrusion to power supply. For more information please refer to power supply and LineLED wiring instructions.

REV0.1
02222024
7777 Merrimac Ave Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals