luminii MKRW Myka Recessed Trimmed Instruction Manual
- May 15, 2024
- luminii
Table of Contents
Myka Recessed Trimmed – Installation Instructions
Models MKRW-XX
MKRW Myka Recessed Trimmed
Please read all instructions prior to installation and keep for future reference!
- PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
- USE ONLY WITH CLASS 2 POWER UNIT.
- SUITABLE FOR WET LOCATIONS. MUST USE APPROPRIATE WEATHERPROOF RATED WIRE CONNECTORS.
- 24 VOLTS DC.
- TYPE IC (CEILING & WALL).
- SUITABLE FOR GROUND MOUNTED-RECESSED, ACCESS ABOVE CEILING REQUIRED.
PLENUM FOR SUCH USE IN ACCORDANCE WITH UL2043
Note: The fixtures can be installed in various mounting materials. As
long as the recessed depth is considered as shown below.
These light fixtures can be installed in a up or down position. Reference
specific model for accurate dimensions.
1.1 On the left is the Myka Recessed Wet with the Gypsum Mounting spring brackets. On the right is the Myka Recessed Wet with the Hard Surface Mounting brackets.
2.1 Route slots onto the surface with the proper width and depth to accommodate aluminum extrusion. Use drawing above as reference.
3.1 For mounting bracket options only:
Prior to installing the fixture, slide the mounting brackets on the back of
the fixture. To evenly distribute the weight of the fixture.
Note: Fixture wires must be considered, prior to installing. Reference
wiring diagram for additional information on step 5.
Note: Follow one of the two mounting options, to properly install
fixture.
4.2 For soft surface mounting bracket option: Bend the adjustable springs to a straight position, followed by pushing the fixture completely inside the cutout slot. Then release the springs to secure.
Follow one of the two options to connect the fixture to the power supply
Option 1- Secure female quick connect to male quick connect. Feed male quick
connect wire through conduit to power supply
6.1 Ensure the correct (wattage & voltage) power supply is used to power the
fixture. Then proceed to connect the fixture wires from fixture to the power
supply. For more information please refer to power supply wiring instructions.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com REV0.2
02012024
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>