luminii MKROC Myka Round Static White Instruction Manual
- May 15, 2024
- luminii
Table of Contents
luminii MKROC Myka Round Static White
Installation Instructions
Please read the complete instructions before installation and keep them for future reference!
-
The product should be installed by a qualified electrician.
-
Before installation ensure power is off at the fuse box to prevent electrical shock.
Note: Before installation, 24VDC power must be present for wiring. Also, review and account for all parts necessary to install properly. -
Snap the lens into the extrusion, then align & center the extrusion to the determined location. Make any reference marks to install the extrusion.
Caution: Safety equipment is recommended when modifications are being made to the extrusion & lens. -
If necessary extrusion & lens can be cut in the field. Using the proper blade for aluminum, cut to the desired length.
-
LineLED can be shortened by cutting along the dashed lines in between the solder pads. Make sure the cut is made on the side of the LineLED without the wire leads. LineLED cannot touch the metal endcap which will shorten the circuit.
Optional Extrusion is not waterproof. If it is going to be installed facing up and in a wet location, drainage holes should be drilled along the inner corner of the extrusion every 12”. Drill 1/16” to 1/8” diameter holes before installing the LED strip.
-
Align the mounting brackets to the edge of the surface, followed by securing each mounting bracket with 1 screw. A mounting bracket must be installed every 23”. Snap the extrusion into the mounting brackets. Reference dimensions for additional details.
Please read the complete instructions before installation and keep them for future reference! -
The product should be installed by a qualified electrician.
-
Before installation ensure power is off at the fuse box to prevent electrical shock.
-
Remove the paper backing from the adhesive tape on the LineLED before installing it into the extrusion. Then push the LineLED into the aluminum extrusion and install endcaps at both ends.
-
Snap the diffuser lens into the aluminum extrusion.
-
If extrusion going to be installed outside, add silicone to the endcaps & the full length of the lens. To help avoid getting water inside the extrusion, but will not make it waterproof.
-
Ensure the correct (wattage & voltage) power supply is used to power LineLED. Then proceed to connect LineLED wires from the extrusion to the power supply. For more information please refer to the power supply and LineLED wiring instructions.
LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
- 7777 Merrimac Ave
- Niles, IL 60714
- T 224.333.6033
- F 224.757.7557
- info@luminii.com
- www.luminii.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>