Luminii MKRO-XX Myka Round Static White Surface Mount Wet Instruction Manual
- May 15, 2024
- luminii
Table of Contents
Myka Round – Installation Instructions
Models MKRO-XX
Myka Round w/ Fixed Clip Mounting
MKRO-XX Myka Round Static White Surface Mount Wet
Please read all instructions prior to installation and keep for future reference!
-
PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
-
PRIOR TO INSTALLATION ENSURE POWER IS OFF AT FUSE BOX
TO PREVENT ELECTRICAL SHOCK. -
USE ONLY WITH CLASS 2 POWER SUPPLY.
-
SUITABLE FOR WET LOCATIONS.
-
SUITABLE FOR INSTALLATION WITHIN THE CLOSET STORAGE SPACE WHEN USED WITH TAPE OUTPUTS 2.8W/FT OR LESS
Note: Refer to the power supply installation instruction for additional
information.
Note: More than one person is recommended for this installation.
1.1 Determine the location of where the fixture(s) will be installed. Lay the
fixture(s) on the surface, and make any necessary reference marks for the
fixed mounting clips. Make marks 4” from each end of the fixture(s) and also
every 23” in between.
1.2 Lay the fixed clip onto the reference mark points and secure using the
provided hardware.
2.1 Follow connector dimensions below and drill hole through surface.
Insert wire lead/connector through surface & snap fixture into the mounting
channel to secure in place.
3.1 Connect +24 VDC red wire from the fixture to the power supply +24 VDC red wire with a wire nut. Connect -24VDC black wire from the fixture to power supply -24VDC black wire with a wire nut.
multiple powerfeed layouts
power supplies at the end of the run
power supplies in the middle of the run
consecutive layout, NOT
RECOMMENDED
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com REV0.2
02012024
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>