luminii MKR-XX Myka Recessed Trimmed Instruction Manual

May 15, 2024
luminii

luminii logo1 MKR-XX Myke Recessed Trimmed
Instruction Manual

luminii MKR XX Myka Recessed Trimmed Models MKR-XX
PLENUM FOR SUCH USE IN
ACCORDANCE WITH UL2043

MKR-XX Myke Recessed Trimmed

Please read all instructions prior to installation and keep for future reference!

  1. PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
  2. USE ONLY WITH CLASS 2 POWER UNIT.
  3. 24 VOLTS DC.
  4. SUITABLE FOR DAMP LOCATIONS.
  5. SUITABLE FOR INSTALLATION WITHIN THE CLOSET STORAGE SPACE WHEN USED WITH TAPE OUTPUTS 5.7W/FT OR LESS.
  6. TYPE IC (CEILING & WALL).
  7. SUITABLE FOR GROUND MOUNTED-RECESSED, ACCESS ABOVE CEILING REQUIRED.

Note: The fixtures can be installed in various mounting materials. As long as the recessed depth is considered as shown below.
These light fixtures can be installed in a up or down position. Reference specific model for accurate dimensions. ![luminii MKR XX Myka Recessed Trimmed

1.1 On the left is the Myka Recessed with the Gypsum Mounting spring brackets. On the right is the Myka Recessed with the Hard Surface Mounting brackets.

2.1 Route slots onto the surface with the proper width and depth to accommodate aluminum extrusion. Use drawing above as reference.
3.1 For mounting bracket options only:
Prior to installing the fixture, slide the mounting brackets on the back of the fixture. To evenly distribute the weight of the fixture.luminii MKR XX
Myka Recessed Trimmed - bracket,

Note: Fixture wires must be considered, prior to installing. Reference wiring diagram for additional information on step 5.
Note: Follow one of the two mounting options, to properly install fixture.luminii MKR XX Myka Recessed Trimmed - Hard
surface 4.1 For hard surface mounting bracket option: Align the mounting brackets to the cutout slot, then carefully push the fixture completely inside to the slot to secure.luminii MKR XX Myka
Recessed Trimmed - Gypsum surface 4.2 For soft surface mounting bracket option: Bend the adjustable springs to a straight position, followed by pushing the fixture completely inside the cutout slot. Then release the springs to secure.luminii MKR XX Myka Recessed Trimmed - power
supply5.1 Ensure the correct (wattage & voltage) power supply is used to power the fixture. Then proceed to connect the fixture wires from fixture to the power supply. For more information please refer to power supply wiring instructions.

luminii logo1 7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com REV0.2
02022024
*LUMINII RESERVES THE RIGHTS TO CHANGE
SPECIFICATION & INSTRUCTION WITHOUT NOTICE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals