Luminii Myka 45 Wet Static White Surface Mount Wet Location Instructions

May 15, 2024
luminii

Luminii - logo

Myka 45 Wet – Installation Instructions
Model MK45W-XX
Myka 45 Wet

Luminii Myka 45 Wet Static White Surface Mount Wet Location
-

Myka 45 Wet Static White Surface Mount Wet Location

Please read all instructions prior to installation and keep for future reference!

  1. PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
  2. USE ONLY WITH CLASS 2 POWER UNIT.
  3. 24 VOLTS DC.
  4. SUITABLE FOR DAMP LOCATIONS.
  5.  SURFACE MOUNT ONLY.

Luminii Myka 45 Wet Static White Surface Mount Wet Location -
hardware

1.1 Determine the location of where the fixture(s) will be installed. Lay the fixture(s) on the surface, and make any necessary reference marks for the concealed bracket.
Make marks 4” from each end of the fixture(s) and also every 23” in between. Use the fixture profile and mounting bracket detail, for any additional details.
1.2 Lay the concealed bracket onto the reference mark points and secure using the provided hardware.

Luminii Myka 45 Wet Static White Surface Mount Wet Location -
hardware1

2.1 Align the mounting brackets to the marks, followed by securing each mounting bracket with 2 screws. Snap the extrusion into the mounting brackets.
2.2 To remove the extrusion from the mounting brackets, carefully insert a flat screwdriver to the bottom edge of the extrusion then pull up until the extrusion pops up.

Luminii Myka 45 Wet Static White Surface Mount Wet Location -
hardware2

3.1 If necessary make any pass through holes for wire lead/connector to the surface, depending on the power feed option. Then snap the fixture into the concealed mounting bracket to secure in place.

4
4.1 Follow one of the two options to connect the fixture to the power supply.
Option 1 – Secure female quick connect to male quick connect. Feed male quick connect wire through conduit to power supply.

Luminii Myka 45 Wet Static White Surface Mount Wet Location -
hardware3

OR

Luminii Myka 45 Wet Static White Surface Mount Wet Location -
hardware4

Luminii Myka 45 Wet Static White Surface Mount Wet Location -
hardware5

5.1 Connect +24 VDC red wire from the fixture to the power supplies +24 VDC red wire using a wire nut. Then connect the -24 VDC black wire from the fixture to the power supplies -24 VDC black wire using a wire nut.

power supplies at the end of the run

Luminii Myka 45 Wet Static White Surface Mount Wet Location - power supplies
at the

power supplies in the middle of the run

Luminii Myka 45 Wet Static White Surface Mount Wet Location -
middle

consecutive layout, NOT RECOMMENDED

Luminii Myka 45 Wet Static White Surface Mount Wet Location
-layout

*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE

Luminii - logo7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com REV0.1
02012024

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals