FANTINI D331AU Built In Single Lever Mixer Instruction Manual
- June 1, 2024
- FANTINI
Table of Contents
FANTINI D331AU Built In Single Lever Mixer
Specifications
- Model: IRNOCUAGHSSI
- Pressure Range : 1.5 BAR – 5 BAR
- Max. Water Temperature : Varies (hot – cold)
- Connection Type: 1/2 NPT and 3/4 NPT
Product Usage Instructions
Installation
Follow these steps for proper installation:
- Ensure the minimum and maximum pressure requirements are met.
- Connect the product to the corresponding NPT connections.
- Align the edges of the product for a secure fit.
Pressure Adjustment
If the water pressure exceeds 5 bar, consider installing a flow restrictor upstream to prevent vibrations and regulate temperature.
Maintenance
Regularly check for leaks and ensure all connections are secure. Clean the product as needed to maintain optimal performance.
FAQ
- Q : What should I do if I experience leaks?
- A: Check the connections for any loose fittings or damaged seals. Tighten connections or replace seals as necessary.
- Q: Can this product handle high water temperatures?
- A : Yes, the product is designed to withstand varying water temperatures, both hot and cold.
DEMENSION
D331AU
These mixers can be used with high-pressure hot water accumulators or with instant water heaters.
D372AU
These mixers can be used with high-pressure hot water accumulators or with instant water heaters
These mixers can be used with high-pressure hot water accumulators or with instant water heaters.
TECHINCAL DETAILS
- Minimum pressure :1 BAR
- Minimum pressure :10 BAR
- Reccomended working pressure :2-5 BAR
- Max. water temperature :80° C – 176° F
- Maximum water temperature reccomended :65° C – 149° F
- Maximum in-let pressure difference (hot – cold) :1.5 BAR
If water pressure is above 5 bar, it is advisable to install a flow restrictor upstream of the water supply to avoid vibrations and regulate temperature.
NECESSARY TOOLS
Please note,
dowels and screws not supplied with the product, for correct fixing choose and use the most suitable type for the support on which you have to fix the product
INSTALLATION
please note screw and dowel are NOT supplied, they must be chosen according to the support.
Figure shows the measures minimum and maximum for cutting tiles and distancese to pre-drill the cover
CONTACT
- 2Fratelli Fantini SpAvia Buonarroti, 4Pella ( NO) ItaliaT
- +39 0322 918411 r.a.
- F +39 0322 969530
- fantini@fantini.it
- www.fantini.it*
111900008000000U Rev. 1
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>