CTA PAD-VMTRAYIC Vehicle Cup Holder Mount with Tray and Induction Charging Case Instruction Manual
- June 13, 2024
- CTA
Table of Contents
CTA PAD-VMTRAYIC Vehicle Cup Holder Mount with Tray and Induction Charging Case Instruction Manual
INSTALLATION:
1. Connecting the Custom Flex Vehicle Cup Holder Mount, VESA Bracket & Round Tray
1A. Align the holes of the round piece of the vehicle cup holder mount (A),
VESA bracket (B) and round tray (C). Insert a M5*14mm screw (E) while holding
a nut (F) from the bottom side, then tighten the screw with the included alien
key tool (G).
1 B. Repeat step 1 to tighten all (4) screws and nuts.
2. Installing Custom Flex Vehicle Mount into the Cup Holder
2A. Insert the bottom base of the mount (A) into the cup holder. 28. Twist the button of the base clock-wise, release the arms to hold it securely.
3. Attaching VESA Compatible Device to VESA Bracket
3A. Align VESA bracket (B) VESA holes with the dock (I). Rotate in with the provided tool (G) until securely fastened
4. Placing Tablet Device Inside Inductive Charging Case
5. Using Tablet as Tabletop or Handheld Mode
6. Charging the Tablet Device in Vehicle
6A. Plug one end of your car power adapter (J) into the dock (I) charging port. Plug the other end into your vehicle auxiliary power outlet.
7. Setting Up Inductive Charging
7A. Align the battery pack (H) to the battery pad (I) on the right side by aligning the magnets, so the tablet charges properly.
8. Proper Charging Setup Indicator
Note the power level displayed on the iPad screen.
8A. Connect the AC/DC power supply to the charging plate as pictured.
8B. Take care to assure that the charging case and back charging plate are aligned properly. When done properly, you’ll see the blue indicator light up on the back of the charging plate.
8C. A blue indicator light tells you your iPad is properly connected to the inductive charging plate.
9. Charging the Tablet Device Into Plug
9A. Plug one end of your power adapter (K) into an outlet. Plug the other end into your inductive charging dock (I) charging port.
Caution : For proper results, please make sure your device is properly
aligned with the inductive charging plate.
Caution : Please do not place or store the product on or near high-
temperature areas like heating devices, open flame, or in hot cars in extreme
heat.
Caution : Please do not place or store the product in or near water,
steam, or in any wet, humid, or damp places.
Power Supply:
Input : AC 100-240V 50/60Hz
Output: DC 12V 1.5A
Rating power: 18W
Cable Length:1.8M
DC Plug: 5.5*2.1 mm male DC Plug
Inductive Charging Case:
Qi Standard: V1 .2.4
Input: DC12V 1.3A
Output: DC5V 2.4A(Max.)
Rating Power: 15W
Efficiency: 80-85%(Max.)
Inductive Distance:3-6mm
Input Socket: 5.5*2.1 mm female DC socket
Output Plug:Apple Lightning Plug
Charging Time :4-4.5 hours)
Environmental Requirements:
Operating Temperature for iPad: 32 to 95 / 0 to 35
Nonoperating Temperature: -4 to 113 / -20 to 45
36 Taaffe Place Brooklyn, NY 11205