FORTIN 2023 Chevrolet Traverse Push Button Vehicle Installation Guide
- August 17, 2024
- FORTIN
Table of Contents
FORTIN 2023 Chevrolet Traverse Push Button Vehicle
Product Information
Specifications
- Vehicle Compatibility: Chevrolet Blazer 2019-2023, Chevrolet Traverse 2018-2023
- Product Type: Immobilizer Bypass Module
- Firmware Version: 70.[41]
- Hardware Interface: CAN Bus
- Made in: Canada
Product Usage Instructions
Installation Requirements:
Before proceeding with installation, ensure the following parts are
available (not included):
- 1X 1Amp Diode
- 1X 5 Amp Fuse
- 1X 1k Ohm Resistor
Mandatory Installation:
The hood pin switch must be installed to enable remote start with the hood
open.
Wiring Connection Guide:
Follow the wiring connections below for proper installation:
Safety Instructions:
This module must be installed by a qualified technician. Incorrect connections
can cause permanent damage to the vehicle.
Programming Options:
Use the Flash Link Updater or Flash Link Mobile tool (sold separately) for
firmware updates and programming bypass options. Frequently Asked Questions
(FAQ)
-
Q: Is the hood pin switch mandatory for installation?
A: Yes, the hood pin switch is mandatory for the proper functioning of the remote start feature. -
Q: Can I update the firmware version without additional tools?
A: No, firmware updates require the Flash Link Updater or Flash Link Mobile tool, sold separately.
SUGGESTED WIRING CONFIGURATION
Parts required (Not included)
- 1X 1Amp Diode
- 1X 5 Amp Fuse
- 1X 1k Ohm Resistor
MANDATORY INSTALL
Notice: the installation of safety elements are mandatory. The hood pin is an essential security element and must be installed.
THIS MODULE MUST BE INSTALLED BY A QUALIFIED TECHNICIAN. A WRONG CONNECTION CAN CAUSE PERMANENT DAMAGE TO THE VEHICLE.
DESCRIPTION
WIRING CONNECTION
KEY BYPASS PROGRAMMING PROCEDURE
REMOTE STARTER FUNCTIONALITY
Notice: Updated Firmware and Installation Guides
Updated firmware and installation guides are posted on our website regularly.
We recommend that you update this module to the latest firmware and download
the latest installation guide(s) prior to the installation of this product.
WARNING
The information on this sheet is provided on an (as is) basis with no
representation or warranty of accuracy whatsoever. It is the sole
responsibility of the installer to check and verify any circuit before
connecting to it. Only a computer-safe logic probe or digital multimeter
should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or
responsibility whatsoever pertaining to the accuracy or currency of the
information supplied. The installation in every case is the sole
responsibility of the installer performing the work and FORTIN ELECTRONIC
SYSTEMS assumes no liability or responsibility whatsoever resulting from any
type of installation, whether performed properly, improperly or any other way.
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module, except for
the replacement of this module in case of manufacturing defects. This module
must be installed by a qualified technician. The information supplied is a
guide only. This instruction guide may change without notice. Visit
www.fortinbypass.com to get the latest version.
TECH SUPPORT
Tél: 514-255-HELP (4357)
1-877-336-7797
This guide may change without notice. See www.fortin.ca for latest version.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>