CONNECTS2 CHFT12C Steering Wheel Control Interface Instruction Manual
- June 1, 2024
- Connects2
Table of Contents
CONNECTS2 CHFT12C Steering Wheel Control Interface Instruction Manual
ABOUT THIS PRODUCT
CHFT12C
Analogue Steering Wheel Control Interface for Fiat Vehicles with 8 Function
SWC
WIRING COLOUR CODES
| Purple | Right Rear Speaker + | Yellow | Permanent 12V |
|---|---|---|---|
| Purple/Black | Right Rear Speaker – | Black | Ground |
| Green | Left Rear Speaker + | Red | Ignition 12V |
| Green/Black | Left Rear Speaker – | ||
| Grey | Right Front Speaker + | ||
| Grey/Black | Right Front Speaker – | ||
| White | Left Front Speaker + | ||
| White/Black | Left Front Speaker – |
PRIOR TO INSTALLATION
Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. Please ensure that the correct tools are using during the installation to avoid damage to the vehicle or product. InterPro can not be held responsible for the installation of this product.
TECHNICAL SUPPORT
f you need assistance setting up or using your Aerpro product now or in the
future, call Aerpro Support Australia
TEL: 03 – 8587 8898 FAX: 03 – 8587 8866 Mon-Fri 9am – 5pm AEST. If you would
like to download a digital copy of this manual, or other Aerpro
manuals/software, please visit the http://aerpro.com website.
FITTING GUIDE
-
Remove and disconnect the original head unit.
-
Connect the 12 way mole connector of the head unit patch lead (supplied separately) to the interface.
-
Connect the opposite end of head unit patch lead to the head unit steering wheel control input on the back of the aftermarket head unit.
NB: This may be a 3.5mm jack plug or a wire input depending upon the head unit brand being fitted. Please see the head unit installation manual for further information on where to connect.
Important: This step must be completed before connecting power to the interface. Failure to so do may result in no steering wheel control function.
-
Connect the 14 way molex connector to the interface
-
Connect the male power/speaker ISO harness to the female power/speaker ISO harness from the aftermarket head unit. For aftermarket head units without an ISO connector, please refer to “Wiring Co lour Codes” on Pg. 2.
FITTING GUIDE -
Connect the female vehicle specific connectors on the harness to the male vehicle connector from the vehicle. Test head unit for correct operation.
STEERING WHEEL CONTROL FUNCTIONALITY
| Original Button | Function |
|---|---|
| + Icon | Volume + |
| – Icon | Volume – |
| Up Arrow | Track + |
| Down Arrow | Track – |
| Mute Icon | Mute |
| Phone Button | Pick Up |
| Window Icon | Hang Up |
| SRC | Source |
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>