CONNECTS2 CTUFT01 Fiat Vehicle Interface Instruction Manual
- June 1, 2024
- Connects2
Table of Contents
CTUFT01
FIAT VEHICLE INTERFACE
INSTRUCTION MANUAL
Application
Fiat Ducato 2014 >
Fiat 500L 2014 >
Fiat 500* 2015 >*
For vehicles with Uconnect system
**www.connects2.com
ABOUT
The Connects2 Infodapter for Fiat vehicles allows vehicle setting and parking
sensor information to be displayed on any aftermarket head unit with rear
camera input.
The Infodapter also allows the use of the steering wheel controls with almost
every steering wheel control compatible head unit on the market.
DIP SWITCH SETTINGS
See Fig 1.
Up = Off, Down = On
- On = Pioneer head units. Off = All other head units
- Setting for reverse camera. On = PAL, Off = NTSC. The default setting is Off (NTSC).
- Resets the display settings back to default. If the display settings have been manipulated in a way that it is no longer possible to make adjustments, change the DIP switch #3 from Off to On and back. This will reset the screen settings to the factory defaults. During this procedure the screen background will change to red. While the background is red, no settings can be made.
- Not applicable
Interface Connections
Steering Wheel Controls
- Speech Button
- Track Up/Down
Configuration Menu
To access the menu, push and hold the speech button for 2 seconds (Fig. 3). This will enable the configuration menu. To navigate through the menu options use the Track Up/ Track Down buttons. To select a menu option, push the speech button once.
-
Vehicle Settings
Vehicle settings can be adjusted via the menu. All vehicle setup options that were available with the original head unit, are now available through the aftermarket head unit. See the vehicle handbook for more information regarding these features. -
Infodapter Settings
-
Screen Size/Position –
Make sure all 4 corner markers are touching the corners of the aftermarket head unit display. -
Picture Settings –
Adjust Brightness, contrast and colour saturation. -
Preferences –
-
Park Assist Version – Select according to the colour configuration of the park
assist fitted to the vehicle.
Camera Connected – Select Yes if an optional camera is connected.
Reverse Priority – Select which image (Camera or Park Assist) will be shown
by default when reversing. The driver can select the desired image by pushing
the Source button (Fig.3) while reversing. (Note this option is only
available when Camera Connected is set to Yes) Park Brake Source – Set to
Speed, Brake or Always On.
Security Type – If the odometer is flashing, change the security type to the
type 2 setting in the ‘Security Type’ menu.
Restore factory settings – Reverts all Infodapter settings to factory
defaults.
(This does not restore vehicle settings)
Legal Information
Please consult the relevant road traffic laws governing the country in which
this product is being operated.
No liability is accepted for material damage, loss or personal injury,
directly or indirectly, from installation and operation of this product. This
product should only be operated when safe to do so.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>