JL AUDIO C6-100ct 1 Inch Component Tweeter Owner’s Manual
- June 2, 2024
- JL AUDIO
Table of Contents
C6-100ct 1 Inch Component Tweeter
Owner’s Manual
C6-100ct 1 Inch Component Tweeter
C6-100ct-120723
Printed in China • © 2023 • JL Audio is a trademark of Garmin Ltd. or its
subsidiaries and is registered in one or more countries, including the U.S.
The JL Audio logo and the C6 logo are trademarks of Garmin Ltd. or its
subsidiaries.
IMPORTANT:
- Installation requires appropriate tools and safety equipment. Professional installation is recommended.
- Before installation, turn off the audio system and disconnect the battery system from the audio system.
- Before cutting or drilling, check for potential obstacles behind mounting surfaces.
- Do not mount this product in an engine compartment or other area of extreme heat.
- Mount this product securely to prevent damage or injury in severe conditions.
WARNING
Listen to your audio system at levels appropriate for operating conditions
and hearing safety.
Product images shown are for illustrative
purposes only and may differ from the actual product. Due to continuous
product development, all specifications are subject to change without notice.
FLUSH MOUNT
SURFACE MOUNT
Passive crossover networks are not
included, as C6 drivers are designed for active systems. For optimum
performance, we strongly recommend the use of a high-quality DSP and a
dedicated amplifier channel.
C6-100ct
| 1.00 in / 25 mm| Re| 3.20 Ω
---|---|---|---
| 80 W| Fs| 1500 Hz
| 10 – 80 W| no| 0.60%
| 3 kHz – 21 KHz ± 3 dB (@ 48 dB/oct)
4 kHz – 21 KHz ± 3 dB (@ 24 dB/oct)
5 kHz – 21 KHz ± 3 dB (@ 12 dB/oct)| Eff| 90.0 dB @ 1W/1m | 96.0 dB @ 1W/0.5m
| 4 Ω| Sens| 93.0 dB @ 2.83V/1m
C6 2-WAY SPEAKER SYSTEM
(2-WAY SPEAKER SYSTEM / 2-WAY SPEAKER SYSTEM / 2-WAY SPEAKER SYSTEM / 2-WAY
SPEAKER SYSTEM)
C6-100ct: High-Pass: 3,100 Hz @ 24 dB/oct | Level Offset: 0 dB
C6-650cw: Low-Pass-Pass: 2,700Hz @ 24 dB/oct | Level Offset: 0 dB
These are recommended starting points for tuning. In-vehicle measurements
should be made to optimize the crossover for speaker placement and vehicle
acoustics. 
WARNING! A high-quality 15μF
protection capacitor is included to guard against damage from transient
electrical pops (turn-on/off). This capacitor is NOT a substitute for high-
pass filtering and MUST be connected in all installations. It is absolutely
vital that the protection capacitor is connected, as shown above. Failure to
connect the protection capicitor as shown will result in damage which is NOT
covered under warranty.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>