JL AUDIO C1-650se Component Speaker System Owner’s Manual
- June 1, 2024
- JL AUDIO
Table of Contents
JL AUDIO C1-650se Component Speaker System
Specifications
- Product: 2-Way Component System
- Size: 6.50 in (165 mm)
- Component Size: 25 mm
- Power Handling: 50 W RMS, 10 – 75 W peak
- Sensitivity: 91.0 dB @ 1W/1m
Installation Options
The component system can be installed using two different methods:
Surface Mount:
- Use #6 screws for mounting (16 mm)
- Depth required: 1/16 in (1.50 mm)
- Recommended hole size: 1/4 in (6 mm)
Flush Mount
- Depth required: 0.375 in (10 mm)
- Recommended hole size: 0.75 in (19 mm)
Adaptor Information
Adaptors are provided for specific applications:
GM Applications
- Use #8 screws for mounting (6 mm and 19 mm)
Honda/Other Applications
- Use #8 screws for mounting (6 mm and 19 mm)
6.50 in (165 mm) 2-Way Component System
OWNER’S MANUAL
Product images shown are for illustrative purposes only and may differ from
the actual product. Due to continuous product development, all specifications
are subject to change without notice. 
WARNING! Failure to use the appropriate filters supplied in this kit will result in damage or failure of the product and will NOT be covered under warranty.
SURFACE MOUNT
FLUSH MOUNT
ADAPTOR: GM APPLICATIONS 
ADAPTOR: HONDA/OTHER APPLICATIONS
IMPORTANT
- I nstallation requires appropriate tools and safety equipment. Professional installation is recommended.
- Before installation, turn off the audio system and disconnect the battery system from the audio system.
- Before cutting or drilling, check for potential obstacles behind mounting surfaces.
- Do not mount this product in an engine compartment or other area of extreme heat.
- Mount this product securely to prevent damage or injury in severe conditions.
Warning
Listen to your audio system at levels appropriate for operating conditions
and hearing safety.