SUPERATV IN-CRS-CA-DEFMAX Defender MAX Outfitter Roof Rack Instruction Manual
- May 15, 2024
- SUPERATV
Table of Contents
INSTALLATION INSTRUCTIONS
Roof Rack: for Can-Am Defender MAX
IN-CRS-CA-DEFMAX Defender MAX Outfitter Roof Rack
Do not discard packaging until product has been successfully installed.
Read instructions and view illustrations before beginning.
Unless noted, hardware should be snug when installing components; not tight.
Liability Statement
SuperATV’s® products are designed to best fit user’s ATV/UTV under stock
conditions. Adding, modifying, or fabricating any factory or aftermarket parts
will void any warranty provided by SuperATV ® and is not recommended.
SuperATV’s ® products could interfere with other aftermarket accessories. If
user has aftermarket products on machine, contact SuperATV ® to verify that
they will work together.
Although SuperATV ® has thousands of satisfied customers, user should be aware
that installing lift kits, long travel, or suspension kits, tires, etc. will
change the ride of machine and may increase maintenance and part wear.
Operating any off-road machine while, or after, consuming alcohol and/or drugs
increases risk of bodily harm or death. No warranty or representation is made
as to this product’s ability to protect user from severe injury or death.
SuperATV ® urges operators and occupants to wear a helmet and appropriate
riding gear at all times.
By purchasing and installing SuperATV ® products, user agrees that should
damages occur, SuperATV ® will not be held responsible for loss of time, use,
labor fees, replacement parts, or freight charges. SuperATV ® , nor any 3rd
party, will not be held responsible for any direct, indirect, incidental,
special, or consequential damages that result from any product purchased from
SuperATV ® . The total liability of seller to user for all damages, losses,
and causes of action, if any, shall not exceed the total purchase price paid
for the product that gave rise to the claim.
SuperATV ® will warranty only parts provided by SuperATV ® . Any damage or
problems with OEM housings, bearings, seals, or other manufacturers’ products
will not be covered by SuperATV ® . SuperATV ® parts and products are not
warrantied if item was not installed properly, misused, or modified.
Installing, adding, modifying, or fabricating any factory or aftermarket
product to your ATV/UTV may violate certain local, state, and federal laws. Be
advised that laws vary depending on town, city, county, state, etc. Use of
certain products on public streets, roads, or highways may be in violation
law. The Buyer is solely and exclusively legally and personally responsible
for any violation of the law by the installation or use of the product. You
must abide by all local, state, and federal laws, including but not limited to
vehicle safety, traffic laws, and ordinances. It is your responsibility to
know the laws and how they apply to you.
The Buyer is responsible to fully understand the capability and limitations of
his/her vehicle according to manufacturer specifications, warnings and
instructions and agrees to hold SuperATV ® harmless from any damage resulting
from failure to adhere to such specifications, warnings and/ or instructions.
The Buyer is also responsible to obey all applicable federal, state, and local
laws and ordinances when operating his/her vehicle while using this product,
and the Buyer agrees to hold SuperATV ® harmless from any violation thereof.
Reference only; do not completely assemble at this time
- Install Brackets and Driver Guard to Driver Panel with hardware shown; do not tighten.
- Repeat for Passenger Panel. Set aside.
- Install Front Panel to Front Bracket and Driver Panel with hardware shown; tighten.
- Install Back Panel to Rear Bracket with hardware shown; tighten.
Install Frame Rails to Driver Panel with hardware shown; tighten.
- Install Passenger Panel to Frame Rails with hardware shown; tighten.
- Secure Passenger Panel to Front Bracket and Panel with hardware shown; tighten.
- Secure Passenger Panel to Rear Brackets with hardware shown; do not tighten.
- Install Covers to Driver Panel with hardware shown; tighten.
- Repeat for Passenger Panel.
- Remove hardware from Roof Clamps. Repeat for passenger side.
- Secure Roof Rack to Roof with previously removed Roof hardware.
- Align to machine and tighten all hardware.
IN-CRS-CA-DEFMAX 3/21/2023
Need help with your installation?
sales@superatv.com
1-855-743-3427
www.superatv.com
8:00am – 8:00pm EST M-Th
8:00am – 7:00pm EST Friday
9:00am – 2:00pm EST Saturday
© 2023 SuperATV.com. All Rights Reserved.
Documents / Resources
|
SUPERATV IN-CRS-CA-DEFMAX Defender MAX Outfitter Roof
Rack
[pdf] Instruction Manual
IN-CRS-CA-DEFMAX Defender MAX Outfitter Roof Rack, IN-CRS-CA-DEFMAX, Defender
MAX Outfitter Roof Rack, MAX Outfitter Roof Rack, Outfitter Roof Rack
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>