DEKKERS Heineken SIGNUM LED SIGN User Manual
- June 5, 2024
- DEKKERS
Table of Contents
DEKKERS Heineken SIGNUM LED SIGN
HOW TO USE
-
Step 01.
Unscrew both crews at the bottom side -
Step 02.
Take off the top cap -
Step 03.
(re)place the battery and attach the battery connector inside Signum -
Step 04.
Place the cap back on top. Make sure there are 2 rubber rings placed in between -
Step 05.
Screw both screws back at the bottom sides. -
Step 06.
Push the spindle with the rubber ring through the bottom hole -
Step 07.
Screw Sign um on top of the of the tap and the handle with flat rubber ring on top of signum
SPECIFICATION
OVERVIEW
-
Wall mount: Use the brackets on the back side of the sign
Ceiling mount: Use the 2 hanging chains for hanging at the ceiling
NOTE: Make sure you use the correct materials suitable for the type of wall or ceiling! -
Connect the 12V power cable of the transformer to the 12V power cable on the back side of the sign.
-
The transformer can be plugged in directly in the wall socket.
-
See for mounting Signum on the tap.
IMPORTANT
- Only use the supplied 110 / 240V – 50-60 Hz 12V /4000mA transformer
- Always switch off the sign when cleaning
- For indoor use only!
- Dry locations only!
- Never place in direct sunlight or nearby heaters/ ovens or other heating equipment
- The cable must not be modified or damaged at all, this could result in a dangerous situation
- Only use the supplied battery for Signum!
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body. This device complies
with Part 15 of the FCC Rules, operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.