super bright leds LFA-P06 2.5W LED Low Voltage Cast Aluminum Path Lights User Manual
- June 17, 2024
- super bright leds
Table of Contents
- super bright leds LFA-P06 2.5W LED Low Voltage Cast Aluminum Path Lights
- Product Information
- Product Usage Instructions
- Installation Instructions
- FAQ
- Safety and Notes Assembly
- Recommended Accessories
- Assembly
- Installation Instructions
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
super bright leds LFA-P06 2.5W LED Low Voltage Cast Aluminum Path Lights
Product Information
Specifications
- Product Name : LED Landscape Path Light
- Recommended Accessories:
- WWN-2212 silicone filled twist on wire connector
- WP14-2DB – 14 gauge landscape wire
- WP12-2DB – 12 gauge landscape wire
Product Usage Instructions
Safety and Notes
Ensure to read all instructions before installation to ensure safe and
proper usage of the LED Landscape Path Light.
Installation Instructions
- Lay fixtures out as they will be installed.
- Run landscape wire (WP14-2DB or WP12-2DB) from the power supply past each light. The wire must be within 3 feet of the mounting stake to allow power connections to be made.
- Use waterproof connectors to connect lights to supply wires as well as wires running to additional lights.
- Using a small shovel, loosen the ground where the fixture will be installed. Press the stake into the ground.
Note: The appearance may vary by model. LFA-P06 is shown, but others are similar.
FAQ
-
Can I use other gauge landscape wires with the LED Landscape Path Light?
It is recommended to use either WP14-2DB (14 gauge) or WP12-2DB (12 gauge) landscape wire for proper installation and performance. -
Do I need to use waterproof connectors for all connections?
Yes, it is essential to use waterproof connectors to ensure safe and reliable connections, both for lights to supply wires and wires running to additional lights. -
How far should the landscape wire be from the mounting stake?
The wire must be within 3 feet of the mounting stake to allow power connections to be made properly.
Safety and Notes Assembly
- For use with outdoor, low-voltage landscape lighting systems ONLY.
- Not for use with submersible or pool/spa equipment.
- Do not submerge in water, the product can be damaged.
- For low voltage use only. Power supply voltage must match fixture
Recommended Accessories
| Part Number | Description |
|---|---|
| WWN-2212 | silicone filled twist on wire connector |
| WP14-2DB | 14 gauge landscape wire |
| WP12-2DB | 12 gauge landscape wire |
Assembly
Installation Instructions
Safety and Notes Assembly
- Lay fixtures out as they will be installed.
- Run landscape wire (WP14-2DB or WP12-2DB) from power supply past each light. Wire must be within 3” of mounting stake to allow power connections to be made.
- Use waterproof connectors to connect lights to supply wires as well as wires running to additional lights.
- Using a small shovel, loosen the ground where fixture will be installed. Press stake into ground. Wetting the ground can loosen soil to ease installation if needed. Note: Do not use a hammer or exert force on the fixture by using it to drive the stake into the ground as this may cause damage.
- Turn on power supply and ensure all fixtures are working. If one or more individual fixtures are not working, check each connection. It is recommended to wrap all connections in electrical or self-fusing tape.
- Bury landscape wire, fixture pigtails, and connectors. A depth of 3” is recommended. Wires and connectors can also be coveredby mulch or stone.
about company
- Rev Date: V1 02/22/2022
- User Manual
- 4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>