CLAYMOR3 CAPON-120D Rechargeable Cap Light User Manual
- June 17, 2024
- CLAYMOR3
Table of Contents
CLAYMOR3 CAPON-120D Rechargeable Cap Light
This portable light contains Li-Polymer batteries. Please follow the user manual before use. If any abnormality is found in the product, discontinue use and contact the dealer or a service center where the product was purchased. Any modifications of this product will void the warranty. Misuse of CLAYMORE products may cause user harm.
Caution
- Do not use near high temperatures such as fires or heating equipment. It may cause explosion and ignition.
- This product is water resistant. However, if left in the rain for a long time, it may cause malfunction. If the product gets soaked, please quickly wipe it off.
- Do not store or use in vehicles exposed to direct sunlight. It may cause explosion and malfunction.
- Do not touch the light source directly as it may become very hot during use.
- Do not use if the product exceeds the operating temperature range (-10 ° C to 40 °C).
- Do not look directly into the LED light source.
- Please do not place in the reach of infants. It may cause swallowing of parts or injury.
- Adult supervision is necessary when used by children. Misuse of the headlamp may cause injury or electric shock.
- Do not insert any metal parts into the terminal block of the connector. It may cause heat, explosion, or electric shock.
- Do not disassemble or modify the product.
- Do not touch the connector with wet hands. There is a danger of electric shock.
- After use, be sure to turn off the power. If not, it may cause leakage.
- When adjusting the angle, please do not bend with force. It may cause damage to the product.
- Dropping or impacting the product can cause damage to the inside of the product, resulting in unexpected failures in normal use. Be careful not to apply impact to the body.
- Be careful not to expose your eyes and skin to UV light for a long time, it may cause damage.
Caution for long-term storage
- To prevent false sensor detection, turn off the sensor when storing after use.
- If the battery is completely drained, the battery indicator might not flash.
If this happens, plug the USB cable back in or press the button to turn the battery indicator on again.
- For long-term storage, fully recharge the battery. (Repeat every six months)
- Please keep in mind that if stored below -10°C the battery life may be affected.
- Please keep it in a dry place without moisture.
Components
Operation
Press shortly to turn on Repeat to turn off light.
Stepless Dimming
When the light is ON, press and hold button to increase the brightness
Repeat to decrease the brightness
5 STEP Dimming
Hold down button and press adjust brightness in 5 steps.
Light blinks once when Maximum and Minimum brightness is reached.
Mode Change
SOS-Flash
When the light is OFF, press the button over 2 seconds to access SOS signal
[Sensor Mode]
While the sensor operating, the sensor indicator will flash. Date action distances range: 5cm
Sensor mode automatic OFF function
To reduce unnecessary power consumption, the sensor mode will automatically
turn off after 2hours when there is no movement.
Power automatic OFF function
If a human body or object continues to be close to the sensor for over 20
seconds, the power is turned off to prevent overheating.
To prevent false sensor detection, turn off the sensor when storing after use.
WARNING: The sensor may not work under sunlight or in very bright places
Instructions
Attaching to a Cap & Hard Hat
Fully insert the clip to the visor of the cap/hard hat and adjust the angle
to use it properly.
Please check if the clip is fully attached to the cap bill before use.
Angle adjustment
Able to adjust up to 180 degrees easy to use focused and diffused light
Wrist strap
- Wear an accessory strap on your wrist, and insert the clip into the strap.
- Secure clip with a snap hook
Wearable kit (Using as Head lantern & Clip lantern
[Head band]
- Attach the headband to the hook of the bracket.
- Fully insert the visor clip of “Cap On” into the bracket. (Angle adjustable
[Alligator clip]: Insert the alligator clip into the hook of the bracket until it clicks into place. Alligator clip attaches easily to backpack, cloths, straps, etc.
Lantern Hook: Compatible with a carabiner or hang on string with a hook
Charging Method
Open the rubber cover and connect the USB cable to charge the lantern
Battery Level Check
When charging, the battery indicator will flicker in 3 steps to show the
battery remaining
(To see the remaining battery, press button)
This lantern contains a memory function that returns to the last setting when
turned off and on.
Contents
Warranty
Item: CLAYMORE Cap on 120D UV
Model No: CLPUV-120
Seller
Date of Purchase
- Thank you for purchasing the CLAYMORE series of Prism Co., Ltd.
- This product has passed strict quality control tests. If the product is not functioning properly, please contact an authorized service center.
Free Service
-
Failure of the product under normal operating conditions during the warranty period will be repaired by Prism or an authorized service center on free of charge.
Some shipping or handling charges may be involved. -
Warranty period: 1 year.
Charged Service
- Damage is caused when the warranty period is over.
- Damage is caused due to the user’s mishandling, abuse, or improper operation.
- Damage caused by arbitrary or personal repair or disassembly in the unauthorized service center.
- Damage from input electricity or cable defect.
- Damage caused by natural disaster
CLAYMORE
Prism Co., Ltd.
- ADDRESS: 221, Pyeongcheon-ro, Bupyeong-gu, Incheon, Republic of Korea
- www.claymorelight.com
- www.prismlight.co.kr
- info@prismlight.co.kr
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>