CLAYMOR3 CLL-781MG/BK/WH Lamp Athena User Manual
- June 17, 2024
- CLAYMOR3
Table of Contents
CLAYMOR3 CLL-781MG/BK/WH Lamp Athena
This portable light contains a Li-ion battery. Please follow the user manual
before use.
If any abnormality is found in the product, discontinue use and contact the
dealer or a service center where the product was purchased. Any modifications
of this product will void the warranty.
Misuse of CLAYMORE products may cause user harm.
Caution
-
When using the product for the first time or storing for an extended period, please charge the battery fully.
-
Keep out of reach of children. (For children under the age of 10, please use under adult supervision.)
-
Do not disassemble, modify, or repair on your own.
-
Do not disassemble, or modify the rechargeable battery. It may cause an accident or injury due to ignition, leakage, heat generation, or rupture.
-
Be careful in humid environments (e.g. bathroom) or flooding. Discontinue use in case of contact with water.
-
If the temperature rises or the outer appearance deforms during charging, discontinue use and contact a customer center.
-
Do not use it in high-temperature environments such as near fire or heating appliances.
It may cause an explosion or ignition. -
Do not touch with wet hands. There is a danger of electric shock.
-
Do not use in conditions exceeding the acceptable operating temperature range (-10°C~40°C).
-
Do not store or use in vehicles exposed to direct sunlight. It may cause an explosion or malfunction.
-
Do not charge it in contact with easily flammable materials like carpets or blankets.
-
After use, be sure to turn off the power for storage.
-
If the product is dropped or experiences physical shock, damage may be accumulated inside the product and unexpected malfunction may occur even during normal use. Be careful not to apply physical shocks to the main unit.
Caution in the use of repeller
- Do not use it in a confined space and make sure to use it in ventilation.
- Do not cover it with a blanket or bedclothes. It may cause ignition.
- Do not put it aside or upside down when it is in operation.
- Do not use it for other purposes except for the intended purpose and method of use.
- Do not use it near combustibles such as furniture, curtains, or sofas.
- Keep out of reach of children.
- Use out of reach of children, and make sure that your children are not to play with the used mat. Throw away the mat after use.
- Do not spill any liquid on the mat.
- Wash your hands off after touching the mat.
- Sneezing, rhinitis, asthma, coma, headache, tinnitus, nausea, etc. may appear as symptoms of poisoning when inhaling pyrethroid. Do not use in a confined space and make sure to use it in ventilation.
- If you have symptoms of poisoning, stop using it. Receive medical treatment immediately.
- Do not touch or put metal on the heat plate when it is in operation.
- Do not cover it with a blanket or bedclothes. It may cause ignition.
- Make sure that the repeller faces upward when it is in operation.
- Turn off the power when it is not in operation.
- Do not touch the hot mat.
- Avoid constant exposure to a sensitive person.
- Be aware that if volatile substance is scattered by air conditioner or fan wind or ventilation, it may be ineffective.
- When using indoors, use only one mat.
Components
Place the leather hook in the opposite direction of the repeller cover.
Operation
LED Lantern Function
- Press the button shortly to turn on the light. On: Mood1 > Mood2 > Mood3 > OFF
When Off states, press the button to display the remaining battery level.
[3 different light moods]
Brightness Control
When the light is on, push and hold the button to adjust the brightness to increase brightness. Push and hold the button once again to decrease brightness.
- The indicator will blink once when the maximum and minimum brightness is reached.
When the Mosquito repeller is on, maximum brightness is limited up to 50%.
Mosquito repeller
Open cover > Put a mat on the heat plate > Close cover
Warning
When using indoors, use only one mat.
- MAT1 ON: When the repeller is Off, Press over 2 seconds
- MAT2 ON: When MAT1 is On, press shortly
- Simultaneous MAT1 and 2 : When MAT2 is on, press shortly
- Repeller OFF: When MAT1&2 is on, press shortly.
ON: MAT 1 > MAT 2 > MAT 1 & MAT 2 > OFF
Warning
Do not touch or put your fingers on the heat plate.
Charging Method
- Open the rubber cover on the back of the lamp and connect a USB-C type cable to charge it. When charging, the battery indicator will flicker.
If the indicator does not blink and stays lit, it indicates charging is complete.
Power Bank Function
-
Open the rubber cover on the back of the lamp and connect the USB cable to the charging port to initiate charging.
When charging, the charging indicator will light up.- It is not possible to charge the product and use the power bank at the same time.
- Charging time may vary depending on the battery capacity of the product o r external devices and the external environment
Specification
Installation
You can put it on the floor/table or use accessories to create a variety of presentations.
Attaching Leg
Fit the provided four (4) legs in the connecting holes as shown in the
picture.
- You can easily fit the legs in the holes by turning it left or right or twisting it.
- More effective if you put the lamp on the floor when the Mosquito Repeller is on.
Handle & Hook
- Handle for convenient portability and it can be hung by connecting a carabiner to a leather hook.
Using tripod socket
- Screw the camera tripod, lantern stand into the 1/4-inch tripod socket at the bottom to fix it. It can be used in various ways by connecting to all products using 1/4 inch screws.
- A lantern stand is not included.
Warranty
- Thank you for purchasing the CLAYMORE series of Prism Co., Ltd.
- This product has passed strict quality control tests. If the product is not functioning properly, please contact an authorized service center.
Free Service
- Failure of the product under normal operating conditions during the warranty period will be repaired by Prism or an authorized service center on free of charge. Some shipping or handling charges may be involved.
- Warranty period: 1 year.
Charged Service
- Damage is caused when the warranty period is over.
- Damage is caused due to the user’s mishandling, abuse, or improper operation.
- Damage caused by arbitrary or personal repair or disassembly in an unauthorized service center.
- Damage from input electricity or cable defect.
- Damage caused by natural disasters.
Prism Co., Ltd
221, Pyeongcheon-ro, Bupyeong-gu, Incheon, Republic of Korea
www.claymorelight.com ·
www.prismlight.co.kr ·
[email protected]