WAC LIGHTING WS-W54614 LED Outdoor Wall Light Instruction Manual
- June 17, 2024
- WAC LIGHTING
Table of Contents
WAC LIGHTING WS-W54614 LED Outdoor Wall Light
546 – LED Outdoor
WS-W54614 / WS-W54620
WARNING
IMPORTANT: NEVER attempt any work without shutting off the electricity.
- Read all instructions before installing.
- System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations.
- Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or switch ”OFF” the circuit breaker switch(es) that con
- Place the wall switch in the “OFF” position.
CAUTION
All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this fixture.
CAUTION When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.
HARDWARE
INSTALLATION INSTRUCTION
PREPARATION
- Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
- Careful unpower aur new terender and alone exission a ture, inca careful oss lose any small parts necessary for installatio
CONNECTING THE WIRES (Fig. 2)
- Remove the mounting screw (C) from the fixture.
- Secure the mounting back plate to the junction box using junction box screws (B).The side of the mounting back plate marked “GND” must face out.
- Connect the Driver’s input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A) are secured. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE(Fig.1)
- Secure the fixture to the mounting back plate using the mounting screw(C) and silicon gasket (D) .
- To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the outside of fixture back plate where it meets the wall. Leave a space at the bottom to allow molisture to escape Fig.3
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue Ontario, CA 91760
WAC Lighting retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>