WAC LIGHTING WS-42725 LED Bath Responsible Lighting Instruction Manual

: June 17, 2024
: WAC LIGHTING

Table of Contents

INSTALLATION INSTRUCTION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

427 – LED Bath
WS-42725, WS-42732

INSTALLATION INSTRUCTION

WARNING
IMPORTANT: NEVER attempt any work without shutting off the electricity.

Read all instructions before installing.
System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations.
Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or switch ”OFF” the circuit breaker switch(es) that control the power to the fixture or room that you are working on.
Place the wall switch in the “OFF” position.

CAUTION

All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this fixture.
CAUTION When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.

HARDWARE WAC LIGHTING WS-42725 LED Bath Responsible Lighting -
HARDWARE

427 – LED Bath
WS-42725, WS-42732 WAC LIGHTING WS-42725 LED Bath Responsible Lighting -
fig PREPARATION

Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
Remove the Allen screws (E1) using Allen wrench (F1), take down the acrylic.
Remove the mounting screws (D1), take down the back plate.
Connect the Driver’s input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box. *Requires Driver to be recessed within the junction box MOUNTING THE FIXTURE (Fig. 1)
Secure the mounting back plate to the junction box using junction box screws (B1), the side of the mounting back plate marked “GND” must face out.
Drill holes in the wall aligned with the key holes located in the back plate, insert the plastic anchors (G1).
Secure the back plate to the mounting ring using junction box screws (B1), fasten it to the wall using wood screws (H1).
Connect the Driver’s output wire as shown in Fig. 2, making sure that all wire connectors (B1) are secured.
Secure the lamp base to the back plate using mounting screws (D1)
Insert the acrylic into the lamp base, secure the acrylic with Allen screws (E1) using Allen wrench (F1).

WAC Lighting retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.

waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760