WAC LIGHTINGWAC LIGHTING WS-180216 Fuse LED 3 inch Brushed Light Instruction Manual
- June 17, 2024
- WAC LIGHTINGWAC LIGHTING
Table of Contents
FUSE
WS-180216, WS-180227, WS-180237
WS-180216 Fuse LED 3 inch Brushed Light
WARNING
IMPORTANT: NEVER attempt any work without shutting off the electricity.
- Read all instructions before installing.
- System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations. Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or switch ”OFF” the circuit breaker switch(es) that control the power to the fixture or room that you are working on.
- Place the wall switch in the “OFF” position.
CAUTION
- All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken. Failure to follow this instruction could invalidate the CSA listing of this fixture.
CAUTION When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.
FUSE
WS-180216, WS-180227, WS-180237
PREPARATION
-
Shut off the power at the circuit breaker and remove existing fixture, including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
Installation -
Drill holes in the drywall aligned with the anchor hole in the mounting plate and insert mounting anchors.
-
Install the provided mounting plate to the junction box using the junction box screws provided.
-
Fasten the wood screws through the mounting plate anchor holes into the mounting anchors to secure the mounting plate .
-
Provide electrical service according to the “National Electrical Code” or your local electrical code to the outlet box.
-
Connect supply wires to fixture wires and insulate with proper wire nuts (Fig. 2):
Connect incoming ground wire to mounting plate ground wire (green or bare).
Connect incoming common wire to fixture common (white).
Connect incoming hot wire to fixture black wire. -
Raise the fixture to the junction box until the fixture screw holes are lined up with the screw holes on the mounting plate.
-
Secure the fixture to the mounting plate using the fixture screws provided.
WAC Lighting retains the right to modify the design of our products at any time as part of the company’s continuous improvement program. DECEMBER 2018
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>