WAC LIGHTING WS-W39828 LED Outdoor Grate Single Light Instruction Manual

INSTALLATION INSTRUCTION
398 – LED Outdoor
WS-W39812/ WS-W39818/ WS-W39828

WS-W39828 LED Outdoor Grate Single Light

WARNING
IMPORTANT: NEVER attempt any work without shutting off the electricity.

• Read all instructions before installing.
• System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations.
• Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or switch ”OFF” the circuit breaker switch(es) that control the power to the fixture or room that you are working on.
• Place the wall switch in the “OFF” position.

CAUTION

• All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this fixture.
  CAUTION When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.

HARDWARE

Fig. 1

PREPARATION

1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.

2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
   MOUNTING THE FIXTURE (Fig. 1)

3. Remove the mounting screw (C) and the rubber gasket (D) from the mounting back plate.

4. Drill holes in the wall aligned with the key holes located in the mounting back plate, insert the plastic anchors (E)

5. Secure the mounting plate to the junction box using junction box screws (B), fasten it to the wall using wood screws (F). The side of the mounting back plate marked “GND” must face out.
   CONNECTING THE WIRES (Fig. 2)

6. Connect the fixture’s wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A) are secured. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
   COMPLETING THE INSTALLATION (Fig. 1)

7. Secure the fixture to the mounting back plate using the mounting screw (C) and the rubber gasket (D).

8. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the outside of fixture back plate where it meets the wall. Leave a space at the bottom to allow mois- ture to escape Fig.3

G0 WAC Lighting retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.

waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760

References

• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>