WAC LIGHTING WS-43613 LED Wall Sconce Light Instruction Manual

June 16, 2024
WAC LIGHTING

WAC LIGHTING logo INSTALLATION INSTRUCTION
43613 – LED Wall Sconce
WS-43613

WS-43613 LED Wall Sconce Light

WAC LIGHTING WS-43613 LED Wall Sconce Light

WARNING
IMPORTANT: NEVER attempt any work without shutting off the electricity.
– Read all instructions before installing.
– System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations.
– Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or switch ”OFF” the circuit breaker switch(es) that control the power to the fixture or room that you are working on.
– Place the wall switch in the “OFF” position.
CAUTION
– All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this fixture.
CAUTION When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.

HARDWARE

WAC LIGHTING WS-43613 LED Wall Sconce Light - HARDWAREWAC LIGHTING WS-43613 LED Wall Sconce Light -
Dimensions

PREPARATION

  1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
  2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.

CONNECTING THE WIRES (Fig. 2)

  1. Remove the assembly nuts (E1) and fixture from the mounting ring.
  2. Connect the driver input/output wire to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
    *Require driver to be recessed within the junction box.
  3. Secure the mounting ring with assembly screw (F1) to the junction box using the junction box screw (B1).WAC LIGHTING WS-43613 LED Wall Sconce Light - Dimensions 1

MOUNTING THE FIXTURE (Fig. 1)

  1. Secure the fixture on the mounting ring using the assembly nuts (E1).
  2. Insert the glass on the fixture, secure it with set screw (C1) and rubber gasket (D1)

WAC Lighting retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.

WAC LIGHTING logowaclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

WAC LIGHTING User Manuals

Related Manuals