Arashi CINSBBKA Charge Case User Manual
- June 16, 2024
- Arashi
Table of Contents
Arashi CINSBBKA Charge Case User Manual
Specifications
Name Charge Case
Model CINSBBKA
Input 5V⎓2A
USB Cable Type A to Type C Cable
Operation Temperature -20℃ – 40℃
Bluetooth
Operation Frequency Blutooth: 2402~2480MHz
Output Power (E.I.R.P.) ＜10dbm
Battery Model 581950PF4-2P
Capacity 1270 mAh
Energy 4.89 Wh
Name of Parts
- Shutter Button
- Power Button
- Q Button
- Speaker
- Type-C Interface
Charging
Charging, power on
Use the USB cable included in the package to connect the Type-C interface of
the GO3 expansion compartment to the USB-A charger. When charging with the
power off, the status indicator light of the expansion compartment will be red
during charging, and the status indicator light will be off when fully
charged.
Camera charging time, Put the GO 3 camera in the expansion compartment, the indicator light of the main unit will be solid red during charging, and it will turn off when the corresponding module is fully charged. When all the lights are off, the charging is usually completed and the battery is fully charged;
Preview
The expansion compartment realizes the preview function of the GO 3 camera.
Touch screen operation
After the camera is turned on, the touch screen displays the camera shooting
interface, and the menu bar displays information such as shooting mode,
battery power and storage capacity. Perform functional operations by clicking
or sliding the touch screen.
-
Click
Tap the screen to hide/show information on the touch screen.
-
Slide down from the top edge
Slide down from the top edge to access the camera settings
-
Swipe the center of the screen left and right
Switch shooting modes.
-
Swiperight from the left edge
Go to album page
-
Swipe left from the right edge
Enter shooting parameter settings.
-
Slide up from the bottom edge
Enter shooting parameter settings.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>