saunalife Ergo-Series E6 Barrel Sauna Installation Guide
- October 30, 2023
- saunalife
Table of Contents
saunalife Ergo-Series E6 Barrel Sauna
Product Information
- Front & Back Walls
- Tools needed: Measuring tape, marker pen, circular saw, water level, hammer, ratchet strap, extra hands, silicone gun (Only glass-wall models), drill, crescent wrench, utility knife, rubber mallet
- Product includes: Wooden front wall, wooden back wall, center stave, cradles, outer bands (B), upper vent, lower vent
Product Usage Instructions
- Read the manual before construction.
- Install the wooden front wall by fixing it diagonally to make the wall more rigid during installation. Use brackets inside and pre-drill holes before screws.
- Install the wooden back wall by pre-drilling holes before screws. Use brackets inside and fix temporarily to support walls. Use a water level to ensure proper installation.
- Leave a 1/4 gap when tightening screws to leave room for adjustment when the outer bands (B) are installed. Use a strap to support boards during installation.
- Join two boards together that will bridge the width of the A gap. It is recommended that the combined boards are approximately 1/4 wider than the gap. Raise slightly before installing the combined board. Fasten the two halves using screws.
- Place the bands around the barrel on the outer side of the cradle. Remove the strap and temporary braces.
- Install upper and lower vents.
- If your sauna is equipped with a front-glass wall, see the front-glass wall installation manual for proper benches installation. Use a level for installation of benches.
- Trim 15A on the end that meets the back wall if needed to accommodate the size of your heater before adding.
Note: Please read manual before construction
Front & Back Walls
E6 Barrel Sauna 59D” x 81H”
Tools needed
Installation
Wooden front wall installation
Wooden back wall installation
E6 Barrel Sauna 59D” x 81H”
E6 Barrel Sauna 59D” x 81H”
E6 Barrel Sauna 59D” x 81H”
Read User Manual Online (PDF format)
Loading......