LOVMOR V3021DR-E Vanity Base Cabinet Instruction Manual
- June 15, 2024
- LOVMOR
Table of Contents
Vanity Base Cabinet
Instruction Manual
MODEL: V3021DR-E
V3021DR-E Vanity Base Cabinet
PART | DESCRIPTION |
---|---|
A1 | Box side panel – left |
A2 | Box side panel – right |
B | Box bottom panel |
C | Box back panel |
D | Face frame |
E | Toe kick panel |
F1 | Drawer face panel |
F2 | Drawer face panel |
G1 | Drawer side panel – left |
G2 | Drawer side panel – right |
H | Drawer bottom panel |
I | Drawer back panel |
J | Door panel |
CAUTION
- Be sure to carefully remove all parts from the carton and ensure that there are no damages to any of them.
- The hardware should be kept away from children when unpacking and assembling this product. Two adults are recommended for assembly.
- Follow the instructions in the instruction manual carefully and strictly to ensure that the product is assembled and operates as intended.
- Do not tighten all the screws until all the adjacent parts have been properly connected. Please do not throw away extra screws. Please refer to the actual product for the screw hole position.
HARDWARE CONTENTS
AA Glide and runner profile x 6 BB Adjustable drawer clips x 6 CC oft – close hinge x 2 Be careful the length of the screws. DD Wood corner block x 4 EE Corner brace x 13 GG 1” Flat head Phillips screw x 4 TOOLS REQUIRED (NOT INCLUDED)
INSTALLATION OVERVIEW
| Insert the drawer on the extended runner. To secure the drawer clips with
the runner, push the drawer in. Upon successful locking, a click can be heard.
Ensure that the hook on each runner profile fits into the corresponding holes
on the drawer back panel.| To level the drawer, use the green spur gears 1 to
adjust drawer left and right, the green spur gears 2 to adjust drawer up and
down, and the green spur gears 3 to adjust drawer inside and outside.
To take the drawer out, push the green clips at the same time to unlock drawer clips.| Use 1/2” flat head phillips screw x 4
| If the door is not level when it is installed, the customer will need to
turn the screw clockwise to extend the hinge or counterclockwise to shorten
the hinge.
Some products may have hinges pre-installed.
To reverse the door, unscrew the 3/4″ round head Philips screws from each
hinge and remove the door panel. Then, reverse the door panel and drill the
3/4” round head Philips screws to each
hinge through the pre-drilled holes to tighten the hinges with cabinet face
frame.|
Dear customers,
Thank you for purchasing our product. If you require assistance, please
contact the customer service team at the retailer where you purchased the
product. The customer service team will be happy to assist you.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>