LOVMOR DCW2442-E Wall Diagonal Corner Cabinet Instruction Manual
- June 16, 2024
- LOVMOR
Table of Contents
LOVMOR DCW2442-E Wall Diagonal Corner Cabinet
PART DESCRIPTION
PART | DESCRIPTION |
---|---|
B | Box bottom panel |
C | Box back panel |
D | Face frame |
J | Door panel |
K | Adjustable shelf |
L | Box top panel |
R1 | Box side panel – left |
R2 | Box side panel – right |
S1 | Box side panel – left |
S2 | Box side panel – right |
CAUTION
- Be sure to carefully remove all parts from the carton and ensure that there are no damages to any of them.
- The hardware should be kept away from children when unpacking and assembling this product. Two adults are recommended for assembly.
- Follow the instructions in the instruction manual carefully and strictly to ensure that the product is assembled and operates as intended.
- Do not tighten all the screws until all the adjacent parts have been properly connected. Please do not throw away extra screws. Please refer to the actual product for the screw hole position.
HARDWARE CONTENTS
CC
Soft-close hinge x 3
Be careful the length of the screws.
-
Included:
1/2” Flat Head Phillips Screw x 6
-
3/4” Round Head Phillips Screw x 3
**EE**
Corner brace x 22
- Included:
1/2” Round Head Phillips Screw x 88
**FF**
Adjustable shelf clip x 10
**GG**
1” Flat head Phillips screw x 8
**HH**
Rubber bumper x 2
**NN**
135 Degree angle brace x 2
- Included:
1/2″ Flat Head Phillips Screw x 4
TOOLS REQUIRED (NOT INCLUDED)
INSTALLATION OVERVIEW
Use 1/2” round head phillips screw x 8
Use 1/2” round head phillips screw x 8
Use 1/2” round head phillips screw x 8
Use 1/2” round head phillips screw x 8
Use 1” Flat head Phillips screw x 6
Use 1/2” round head phillips screw x 20
Use 1/2” round head phillips screw x 20
Use 1” Flat head Phillips screw x 2
Use 1/2″ Flat Head Phillips Screw x 2
Use 1/2″ Flat Head Phillips Screw x 2
Use 1/2” round head phillips screw x 8
Use 1/2” round head phillips screw x 8
Use 1/2” Flat Head Phillips Screw x 6
Use 3/4” flat head phillips screw x 3
If the door is not level when it is installed, the customer will need to turn the screw clockwise to extend the hinge or counterclockwise to shorten the hinge.
Some products may have hinges pre-installed.
To reverse the door, unscrew the 3/4″ round head phillips screws from each hinge and remove the door panel. Then, reverse the door panel and drill the 3/4” round head phillips screws to each hinge through the pre-drilled holes to tighten the hinges with cabinet face frame.
Thank you
Dear customers,
Thank you for purchasing our product. If you require assistance, please
contact the customer service team at the retailer where you purchased the
product. The customer service team will be happy to assist you.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>