ESORUN DOCK5 Magnet Wireless Power Bank User Manual
- June 4, 2024
- ESORUN
Table of Contents
**ESORUN DOCK5 Magnet Wireless Power Bank User Manual
**
What’s Included
-
Welcome Guide xl
-
Magnetic Power Bank xl
-
1M USB-A to Type-C Cable xl
Specification
Battery Capacity | 5000mAh |
---|---|
Rated Capacity | 3250mAh |
Type C Input | 5V/2.5A, 9V/2A, 12V/1.5A (Maxl8W) |
Type C Output | 5V/2.4A,9V/2.22A,12V1.5A (Max 20W) |
Wireless Output | 5W, 7.5W, lOW (Max) |
Simultaneous Output | 5V/3A |
Charging Efficiency | 75°/0 |
Transmission Distance | 6mm |
Product size | 4.452.670.51 inch |
Weight | 5.82 oz (165g) |
Product Structure
- Wireless Charging Area *P6
- Power Rate Indicator —– *P3
- Wireless Charging Status Indicator *P3
- Pass-through charging via Type C Input/Output – *P7-P8 O
- Heat Dissipation Design
- Switch – *P5
- Foldable &Adjustable Aluminum Stand (0-180°) *P4
- Copper Sheet for the Charging Dock (DMS03 )
LED Usage
Power Rate indicator
Fully Charged | Green LED Stays On |
---|---|
Low Battery | The 1st LED Flashes |
Charging the Power Bank | Green LED Flashes |
Wireless Charging
Working Properly| Blue LED Breathing
---|---
Fully Charged| Blue LED Breathing
FOD| Blue LED Flashes
Stand
The stable stand of this power bank is not only for the angle-adjusting, but
also can be folded to flat for travelling. You can adjust the angle(0-180°)
according to your needs. When you need not to charge, you can use it as a
simple MagSafe stand to support your phone (in horizontally or vertically).
Just need depressing the switch by double quick press.
Please Note: Certain Vibration will restart the Charging Again.
How To Use
Use of Switches
Single Press: Turn on
Double Press: Turn Off
Press the switch once to power on the product the battery indicator will light
up. Then it is in the standby state and other devices can be charged. Press
the switch twice continuously, then the output will turn off.
Tips: In standby mode it will turn off automatically after about 35
seconds without performing other.
Wireless Charging Operation
Please fit the product with the back of your iPhone (12, 13, 14 series or Airpods 3) or other wireless charging phone (which with Mag safe-compatible ring attached, it will charge your phone automatically via the built-in magnetic wireless charging, Max to be 15W, iPhone series is 7.5W due to iPhone’s restrict.
Note:
- The magnetic wireless power bank is mainly used for iPhone 12, iPhone 13, iPhone 14 series, or phones with magnetizing rings attached. And it can also used with Air pods 3.
- The power bank has a built-in vibration sensor when you place the iPhone or Air pods 3 in the charging area, then charging will automatically turn on ( If you just want to use the magnetic stand function, just double-click on the power switch to turn off the charging function).
Charging The Power Bank
Please recharge the product when the power or battery is low.
- Using the included cable (like USB-A to Type-C cable or C TO C), connect the USB-A or C connector into QC/PD adapter and the Type-C connector to the input connector of the power bank.
- During charging, Green LED indicators will flash to show charging status.
- When charging is complete the Green LED indicators will stays on.
Power Bank Operation
- Insert the charging cable USB A or Type C end into Output.
- Plug the other end of the cable into a terminal such as phone.
Pass Through Charging
You can put (Stick to) your iPhone 12/13/14 series, Airpods 3 on the charging
area and connect this power bank to the power source (PD or QC Adapter). It
will charge the power bank itself and your iPhonel2/13/14/Airpods 3 at the
same time.
Warning
- Do not drop, misuse or apply excessive force to your power bank. Power banks contain batteries and a circuit board with fragile components that can be damaged if misused.
- If your power bank swells or bulges, stop use immediately and dispose of the power bank in an appropriate manner.
- Store power bank in a cool and dry place. Do not store in hot or humid environments.
- All power banks have safety power cut off features to stop overcharging & overheating.
- When charging a device the power bank may feel warm, this is a normal operating condition & should not be cause for concern.
- It’s normal that this charger and your smart phone will be hot under operating conditions and it may be more hotter when charging and using at the same time (such as playing music).
- In normal conditions, battery performance will decline over several years.
Remarks
When your wireless power bank works improperly
- Make sure there is no any clutters on the wireless power bank, such as magnet, metal, credit card and other foreign object.
- When the wireless power bank is over-heating take your mobile device away from your wireless power bank and the power bank will stop charging automatically when over-heating. Please try charging again when the wireless power bank cooling down.
FCC Statements
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>