ESORUN Mag 4000W Wireless Power Bank User Manual
- June 6, 2024
- ESORUN
Table of Contents
Mag 4000W Wireless Power Bank
68.00mm
UserManual
Model:Mag4000W
Note: Thank you for your purchase, the wireless charger is widely
compatiblewithallQidevices,likeSamsungS7/S7edge,S8/S8edge,
S9/S9edge,S10/S10edge,S20/S21,iPhone8/8Plus,iPhoneX,iPhone
XR,iPhoneXS,iPhoneXSMAX,iPhone11,iPhone11Pro,iPhone11Pro MAX. iPhone 12mini,
iPhone 12, iPhone 12 Pro, iPhone 12 Pro MAX,
iPhone13mini,iPhone13,iPhone13Pro,iPhone13ProMAX. P l e a s e r e a d t h i s
m a n u a l c a r e f u l l y b e f o r e u s i n g t h i s p r o d u c t f o
r b e t t e r experience.
Accessories:
PRODUCTSTRUCTURE
WirelessChargingArea Magnet
LEDUSAGE
PowerRateIndicator
FullyCharged LowBattery ChargingthePowerBank
WhiteLEDStaysOn The1stLEDFlashes RedLEDFlashes
1 Power %- %
2
3
Power %- % Power %- %
Usermanual×1
WirelessPowerBank×1
TypeCCable×1
SPECIFICATIONS
Capacity TypeCInput TypeCOutput WirelessOutput SimultaneousOutput Dimension
Weight
4000mAh 5V/2.1A,9V/2A 5V/2A,9V/2A,12V/1.5A 10W(Max) 5V/3A 3.912.460.5inch 99.662.512.8mm 3.98oz(113g)
PowerRateIndicator WirelessChargingStatusIndicator
Type-CInput/Output
Switch
WirelessChargingStatusIndicator
Standby WorkingProperly
Over-voltage Lowvoltage
FOD
RedLEDStaysOn WhiteLEDStaysOn RedLEDFlashes RedandWhiteLEDFlashes
120.00mm
HOWTOUSE Switch
SinglePress:Turnon DoublePress:TurnOff Tips: In standby state, if you do not
perform other operations, it will
automaticallyshutdownafterabout30seconds.Ifyouneedtouse
itagain,pleasepresstheswitchagain.
Charging When the product is out of power or low battery, then you need to
charge the product. You can use the standard USB charging cable with Ty pe C
connector to connect this product , and plug the USB A into a 5V/2A charging
device such as a car charger, household appliances,etc.tochargetheproduct.
In
Remarks It’s normal that this charger and your smart phone will be hot under
operating conditions, and it may be more hotter when
chargingandusingatthesametime(suchasplayingmusic)
Whenusingthewirelesschargingfunction,pleasebecarefulnotto
carryothermetalobjectsonthebackofthephone.
Magnets
CreditCards
MetalCases
WirelessCharging Please fit the product with the back of your iPhone, it will
charge your iPhone automatically via the built-in magnetic wireless
charging,Maxtobe10W.
Out
Whenyourwirelesschargingisnotworkingproperly
· Cleantheclutteronthewirelesspowerbank. · When the wireless power bank is
overheating, keep your mobile device away from the wireless transmitter.
Please try charging againwhenthewirelesspowerbankcoolingdown.
1.InserttheTypeCchargingcableTypeCendintoOutput.
2.Plug the other end of the cable into a terminal such as a mobile phone.
3.Presstheswitchbuttonandthepowerisdischargedtochargethe
terminalsuchasamobilephone.
MadeinChina
Mag4000W- 20211124
100g 68x120mm
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: · Reorient or relocate the receiving antenna. ·
Increase the separation between the equipment and receiver. · Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. · Consult the dealer or an experienced radio/TV
technician for help.
Caution: Any changes or modifications to this device not explicitly approved
by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.