ESORUN Silipad 3 Coils Wireless Charger User Manual
- June 5, 2024
- ESORUN
Table of Contents
ESORUN Silipad 3 Coils Wireless Charger
Accessories
- Wireless transmitter x1
- Type C data cable x1
- User manual x1
**Note:**
Thank you for your acquisition of this wireless transmitter, compatible with all Qi devices like Samsung 57/57 edge, 58/58 edge, 59/59 edge, 510/510 edge, iPhone 8/8 Plus, iPhone X, iPhone XR, iPhone XS, iPhoneXS MAX, iPhone 11, iPhone 11 Pro, iPhone 11 Pro MAX.
For optimum performance and safety, please read this manual carefully before using this product.
Specifications
Power: 15W(Max)
Weight: 232g
Input Voltage: 5V /2A; 9V /1 .34A; 9V /2A; 12V /1 .67 A
Output Voltage: 5V /1 A; 9V /0.83A; 9V /1 .12A; 9V /1 .67 A
Size: 126656.5 mm
Charging Efficiency: >80%
Transmission Distance: <6mm
① LED
② Input port
③Transmitter
How to Use
Charging your wireless transmitter
- Charge your wireless transmitter via included Type C data cable.
- Wireless transmitter is ready for your mobile device.
Charging mobile device from wireless transmitter
Put your mobile device (the phone you used must could support the wireless
charging or your phone are equipped with wireless receiver chip) on the
wireless transmitter.
When your wireless transmitter working improperly
- Clean the clutters on the wireless transmitter.
- When the wireless transmitter is over-heating, take your mobile device away from your wireless transmitter.And the transmitter will stop charging automatically when over-heating. Please try charging again when the wireless transmitter cooling down.
Remarks
- The car charger your used should meet with QC2.0,QC3.0 or QC4.0 standard.
- The Type C charging cable you used should be the data cable, not the charging function only.
- It’s normal that this charger and your smart phone will be hot under operating conditions, and it may be more hotter when charging and using at the same time( such as looping music).
- The car charger is not included. A car charger is required .
- Not works with SV/1 A or lower input. For safety, Please do not use below 5V /1 A input charger or USB port to power up.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
The device has been evaluated to meet general RF exposure requirement. The distance between user and products should be no less than 20cm.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>