Shenzhen Esorun Technology MAGQOOA Magnetic Wireless Charger User Manual
- June 6, 2024
- Shenzhen Esorun Technology
Table of Contents
Magnetic Wireless Charger
User Manual
Note: For best performance and safety, please read this manual carefully before using the product.
Product Diagram
User Instruction: 1. Connect with wall charger
When using this product, please plug the type-C connector into the charger so
as to ensure it is in standby mode_
Note: In order to get the best charging effect, please use the adapter that meets the QC2.0, QC3.0 or QC4.0 standard. In order to save energy and extend the product life, please cut off the power when you「phone fully cha「ged to avoid wasting energy
Attention: for safety reasons, please do not use any adaptor which is under 5v/1A.
User Instruction: 2. Charging your iPhone
Please fit the product with the back of your iPhone, it will charge your
iPhone automatically via the built-in magnetic wireless charging, Max to be
15W.
Remark:
- When the surface gets dirty, please wipe it with a damp cloth and dry it before using.
- Please remove foreign objects on the surface before using, such as coins, pins, keys, and other metal objects.
Specifications:
Input | 5V/2A, 9V/1.34A, 9V/2A,12V/2A |
---|---|
Wireless Output | 5V/1A,(5W) 9V/0.83A,(7.5W) |
9V/1.12A,(10W) 9V/l.67A(l5W)
Charging Efficiency| ;;,so%
Cable Length| 1 Meter
Product Size| ¢63mm, THKB.5 mm
Made in China
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement. The distance between user and products should be no less than 20cm.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>