ESORUN TECHNOLOGY DMS04 10000mAh 5 In 1 Detachable Magnet Wireless Power Dock User Guide

ESORUN TECHNOLOGY DMS04 10000mAh 5 In 1 Detachable Magnet Wireless Power

Dock

Product Information

Specifications:

• Compliance: Part 15 of FCC Rules
• RF Exposure Compliance: Meets general RF exposure requirements
• Radiation Exposure Limits: Complies with FCC limits for uncontrolled environments
• Safety Distance: Minimum 20cm distance between the radiator and the body during installation and operation

Product Usage Instructions

Caution and FCC Compliance:

It is important to note that any changes or modifications to the device that are not explicitly approved by the manufacturer may void your authority to operate the equipment. The device complies with part 15 of the FCC Rules, which means it must adhere to specific operational conditions:

1. The device should not cause harmful interference.
2. The device must accept any interference received, even if it causes undesired operation.

RF Exposure Requirements:

The equipment has been evaluated to meet general RF exposure requirements. To ensure compliance with FCC radiation exposure limits:

• Install and operate the equipment with a minimum distance of 20cm between the radiator and your body.

FAQ

• Q: What should I do if I want to make changes to the device?
  • A: Any modifications or changes not explicitly approved by the manufacturer could void your authority to operate the equipment. Please contact the manufacturer for guidance on approved modifications.
• Q: Is it safe to use the equipment close to my body?
  • A: For compliance with FCC radiation exposure limits, it is recommended to maintain a minimum distance of 20cm between the radiator and your body during installation and operation.

Thanks for your support of this magnetic wireless charging station, please read this guide carefully before enjoying this product.

What’s Included

Wireless Charging Dock-Specifications

Wireless Charging Dock-Product Structure

1. Wireless Charging Area for Power Bank
2. Pogopin
3. TWS Earphone Indicator / Power Indicator
4. Wireless Charging Area for TWS earphone or other Qi-enabled devices
5. Non-slip Mat
6. Wireless Charger for Apple Watch
7. Type-C Input
8. USB A Output

Wireless Charging Dock-LED Usage

Earphone charging indicator:

Connected Indicator:

When connected the source, the LED light near the earphone wireless charging area is red on. When your charge earphone, this LED light is changed to earphone wireless charging indicator.

Wireless Charging Dock-Stand

Apple Watch Charger-Product Structure

• 9 Wireless Charging Area for Apple Watch
• 10 Type-C Input
• 11 Watch Charging Indicator

Apple Watch Charger-Specifications

Apple Watch Charger-LED Usage

Watch charging indicator

Power Bank

Specifications

Product Structure

• 12 Wireless Charging Area

• 13  Indicator

• 14 Pass-through charging via Type C Input/Output

• 15 Switch

• 16 Heat Dissipation Hole

• 17 Copper Sheet for the Charging Dock
  (DMS04,4 in 1 Charging Station, Will release soon.)

• 18 USB-A Output

• 19 Foldable & Adjustable Aluminum Stand (0-180°)

Digital Display Screen

Tips:

1. If the wireless charging mark off, please kindly check whether there is magnet or metal element to effect.
2. If wired charging, there is not wireless charging mark on the screen.
3. When start to charge, it would not show fast charging mark immediately. It need several seconds to change to fast charging mode.
4. When the power bank only charge 1 device, it’s fast charging. If charge 2 or more devices simultaneously, the max output power 5V/3A, not fast charging.

Switch & Stand
The stable stand of this power bank is not only for the angle-adjusting, but also can be folded to flat for travelling. You can adjust the angle(0-180°) according to your needs. When your phone don’t need to charge, it can be a simple MagSafe stand to support the phone (in horizontal or vertical). Just double quick press the switch to power off.

How To Use

Please use the included QC 18W adapter and cable to connect this wireless charging dock to the power source.

Wireless Charging Dock – Extra USB Output

Using the USB-A to Type-C cable(Not Included), connect the USB-A cable into the dock and the other side to the devices you want to charge, such as iPad, phone, earphone, Switch and so on.

Wireless Charging Dock – Wireless Charging for power bank

After connecting the power source, please put the power bank in the charging dock and make sure that the copper sheet on the power bank bottom is touched with that of charging dock. It will charge automatically. The specific figures on theLED screen of power bank will show the charging status.

Wireless Charging for phone
Please fit the product with the back of your iPhone (12,13,14 and subsequent series or AirPods 3) or other wireless charging phone (which with MagSafe- compitable ring attached), it will charge your phone via the built-in magnetic wireless charging, Max to be 15W. iPhone series is 7.5W due to iPhone’s restrict.

Note:

If power bank and phone are charged simultaneously, it’s fast wireless charging for phone while power bank is in slow charging. When the phone full charged, the power bank is in fast charging mode.

Wireless Charging Dock – Wireless charging for Apple Watch

Please insert the watch charger into the corresponding position of the charging dock.

Wireless Charging Dock – Wireless charging for Apple Watch

Please make sure your Apple Watch is corresponded to the area of the wireless charger for Apple Watch. It will automatically detect the Apple Watch and charge it.

Wireless Charging Dock – Wireless charging for TWS earphone

Please lay down your earphone on the charging area and then it will automatically detect and charge(5W Max).

Wireless Charging Operation
Please press the button on the top left firstly when charge devices. And then fit the product with the back of your iPhone (12,13,14 and subsequent series or Airpods3) or other wireless charging phone (which with MagSafe- compitable ring attached). It will charge your phone via the built-in magnetic wireless charging, Max to be 15W. iPhone series is 7.5W due to iPhone’s restrict. Note: If just need to be a phone stand, please double press the button to turn off.

Note:

1. The magnetic wireless power bank is mainly used for iPhone 12, iPhone 13, iPhone14 and subsequent series, or phones with MagSafe-compitable ring attached. (Please note some of magnetic rings from the 3rd might not work). And it can also used with AirPods 3.
2. If your phone without MagSafe case, please charge it via the Type C output port or USB-A output port.

Charging The Power Bank

• Please recharge the product when the power or battery is low.

1. Using the included cable, connect the USB-A connector into QC/PD adapter and the Type C connector to the input connector of the power bank.
2. During charging or complete, the battery power LED indicator will show charging status with the specific figures.

• Pass Though Charging
• You can put your iPhone 12/13/14 and subsequent series, AirPods 3 on the wireless charging area and connect this power bank to the power source (PD or QC Adapter). It will charge the power bank itself and your iPhone12/13/14/AirPods 3 at the same time.
  Note:
  While pass though charging, the phone will be in fast charging and power bank is in slow charging. When phone is fully charged, the power bank is in fast charging mode.

USB-A Output Operation

1. Insert the charging cable in to USB-A output port
2. Plug the other end of the cable into a terminal such as phone, iPad, earphone, Switch and so on.

Note:

When the power bank only charge one device, whether C port or wireless charging area, the output support fast charging; if two device, the maximum output power is 5V/3A, no fast charging.

Type C Output Operation

1. Insert the charging cable Type C end into Output.
2. Plug the other end of the cable into a terminal such as phone.
3. Using the USB-A to Type-C or C-C cable (Not included), connect the C cable into the power bank and the other side to the devices you want to charge, such as iPad, phone, earphone, Switch and so on.

Note:

When the power bank only charge one device, whether C port or wireless charging area, the output support fast charging; if two device, the maximum output power is 5V/3A, no fast charging.

Warning

• Do not drop, misuse or apply excessive force to your power bank. Power banks contain batteries and a circuit board with fragile components that can be damaged if misused.

• If your power bank swells or bulges, stop use immediately and dispose of the power bank in an appropriate manner.

• Store power bank in a cool and dry place. Do not store in hot or humid environments.

• All power banks have safety power cut off features to stop overcharging & overheating.
  When charging a device the power bank may feel warm, this is a normal operating condition & should not be cause for concern.

• It’s normal that this charger and your smart phone will be hot under operating conditions and it may be more hotter when charging and using at the same time (such as playing music).

• In normal conditions, battery performance will decline over several years.

Remarks

When your wireless power bank works improperly

1. Make sure there is no any clutters on the wireless power bank, such as magnet, metal, credit card and other foreign object.
2. When the wireless power bank is over-heating take your mobile device away from your wireless power bank and the power bank will stop charging automatically when over-heating. Please try charging again when the wireless power bank cooling down.

FCC  statements

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>