TeeHo TZ001 Keypad Door Lock User Guide

TeeHo TZ001 Keypad Door Lock User Guide

Parts illustrations

⚠ The default master code Is 12345678. It’s required that you change 1t to a code of your own before programming.

How to use?

Quick set up

⚠ The default master code is 12345678. It’s required that you change 1t to a code of your own before programming
⚠ When setting Is unsuccessful the Indicator light will flash red

Information and safety warnings

⚠ Do not load batteries until look 1s completely installed.

• Protect your user codes and master code.
• Restrict access to your lock’s interior assembly and routinely check your settings to ensure they have not been altered without your knowledge.
• This lockset is designed to provide the highest standard of product quality and performance. Care should be taken to ensure a bng-lasting finish. When cleaning is required use a soft and damp cloth. Using lacquer thinner, caustic soaps, abrasive cleaners or polishes could damage the coating and result in tarnishing.

1. Master PIN Code (4~10 digits): The default master pin code is ” 7 2345678″, It’s required that you change It t o a code of your own before programming.
2. User PIN Code (4-10 digits):A total of 20 user codes(and one temporary one- time user code) may be programmed.
3. Both master and user PIN COOes don’t support the following combination of numbers below.

Definitions

1. Master Code
   □ Required for programming and feature settings. Master code can be used to unlock the door under vacation mode.
   The default master code needs to be changed before programming.
   □ Property owner/manager should keep this information confidential.

2. Auto Lock
   □ Automatically locks the deadbolt 30 seconds after unlocking. This feature is off by default. You can set the Auto
   Lock time delay between 10 and 99 seconds.

3. Wrong Entry Limit
   □ After 10 unsuccessful attempts at entering a Invalid PIN code, the unit will shut down for 3 minutes.

4. Silent Mode
   □ The beep sounds when pressing keypad can be muted. But you will still hear low battery and system alerts.

5. Vacation Mode
   □ This is a security feature for you when you are leaving your home for vacation or long trip. Enabling vacation mode will restrict all user codes until master code is entered on keypad. If the lock is unlocked by thumb tum, the lock will sound an alarm.

6. One Time User Code
   □ This code can only be used once and Is automatically deleted when used.

7. Unlock with Fake Code
   □ User can prevent pin code exposure from strangers by entering random digits before or after pin code.

Factory default settings

Restore factory default settings

⚠ This procedure will delete all user codes which associated with the lock.

1. Keep the door opening and unlocking;
2. Press and hold the reset button, taking out one battery and then place it back at the same time;
3. Keep holding the reset button for 3 seconds until you hear the sound of “BEEP”.

Troubleshooting

2 Operation

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>