TeeHO G2 Gateway for Smart Door Lock User Manual
- June 14, 2024
- TeeHO
Table of Contents
TeeHO G2 Gateway for Smart Door Lock
Specifications
- Model: G2
- Dimensions: 70mm x 70mm x 26mm
- Network: WiFi 2.4G
- IEEE standard: 802.11 b/g/n
- Power interface: Type-C USB
- Power input: 5V/500mA
Thank you for purchasing our products. Please review this manual thoroughly before operating your device. All pictures in this manual are for illustration purposes only. Actual products may vary due to product upgrades.
SMART LOCK GATEWAY G2
- Model: G2
- Dimensions: 70mm x 70mm x 26mm
- Network: WiFi 2.4G
- IEEE standard: 802.11 b/g/n
- Power interface: Type-C USB
- Power input: 5V/500mA
Light Status
Pair with App
- Open the App
- Tap on “ ” on the upper left corner of the screen
- Select [Gateway]|
- Select [ G2 ]
- Plug in the Gateway and power it on
- While the light is flashing in Red and Blue alternately, tap on “ + ”
- Add Gateway
- Select the network and enter your Wi-Fi password
FCC
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmtul interterence,
- this device must accept any interterence recelved, including interterence that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, If not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Disclaimer
We continuously optimize products as new technologies and features are
developed. For this reason, we reserve the right to make alterations to the
products without prior notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>