TeeHO TE002 Keypad Deadbolt with Fingerprint Instructions

Table of Contents

TeeHO-TE002-Keypad-Deadbolt-with-Fingerprint-fig-1

The default master code is 12345678. It’s required that you change it to a code of your own before programming.

ITEM
Battery Using only new and non-rechagerable Alkaline betteries for the best results.)
SPECIFICATIONS
AA alkaline battery ×4 (Operation voltage:4.6~6.OV)
REMARKS
Last up to one year (10 times open/close per day)

TeeHO-TE002-Keypad-Deadbolt-with-Fingerprint-fig-2

TeeHO-TE002-Keypad-Deadbolt-with-Fingerprint-fig-3

Auto re-lock mode
In auto re-lock mode, the bolt will extend out automatically in 30 seconds after unlocking.\
Manual mode
Press any of the buttons on keypad for 2 seconds.

Auto re-lock mode
In auto re-lock mode, the bolt will extend out automatically in 30 seconds after unlocking.
Manual mode
Rotate the turn piece to lock position.

TeeHO-TE002-Keypad-Deadbolt-with-Fingerprint-fig-6

Do not load batteries until lock is completely installed.

Protect your user codes and master code.
Restrict access to your lock’s interior assembly and routinely check your settings to ensure they have not been altered without your knowledge.
This lockset is designed to provide the highest standard of product quality and performance. Care should be taken to ensure a long-lasting finish. When cleaning is required use a soft and damp cloth. Using lacquer thinner, caustic soaps, abrasive cleaners or polishes could damage the coating and result in tarnishing.

Master PIN Code (4~10 digits): The default master pin code is “12345678”, It’s required that you change it to a code of your own before programming.
User PIN Code (4~10 digits):A total of 20 user codes(and one temporary one-time user code) may be programmed.
Both master and user PIN codes don’t support the following combination of numbers.

Master Code
- Required for programming and feature settings. Master code can be used to unlock the door under vacation mode. The default master code needs to be changed before programming.
- Property owner/manager should keep this information confidential.
Auto Lock
Automatically locks the deadbolt 30 seconds after unlocking. This feature is off by default. You can set the Auto Lock time delay between 10 and 99 seconds.
Wrong Entry Limit
After 10 unsuccessful attempts at entering a invalid PIN code, the unit will shut down for 3 minutes.
Silent Mode
The beep sounds when pressing keypad can be muted. But you will still hear low battery and system alerts.
Vacation Mode
This is a security feature for you when you are leaving your home for vacation or long trip. Enabling vacation mode will restrict all user codes until master code is entered on keypad. If the lock is unlocked by thumb turn, the lock will sound an alarm.
One Time User Code
This code can only be used once and is automatically deleted when used.
Unlock with Fake Code
User can prevent pin code exposure from strangers by entering random digits before or after pin code.

TeeHO-TE002-Keypad-Deadbolt-with-Fingerprint-fig-9

This procedure will delete all user codes which associated with the lock.

Keep the door opening and unlocking;
Press and hold the reset button, taking out one battery and then place it back at the same time;
Keep holding the reset button for 3 seconds until you hear the sound of “BEEP”