TeeHO TE001 Keypad Deadbolt Instruction Manual

TeeHO TE001 Keypad Deadb olt Instruction Manual

Parts List

The details of part identification is shown on following page

Prepare the door and check dimensions

Mess sure to confirm that the hole in the door is 2-1/8 (54mm)

Measure to confirm that the backset is either 2-3/8”0r 2-3/47(60 or 70mm).

Measure to confirm that the hole in the door is 1(25mm).

Measure to confirm that door thickness is between 1-3/8” and 2” (35mm to 50mm).

Choose faceplate

Is the Slotted hole centered in the door hole

Install latch and deadbolt

IMPORTANT: Keep the latch loon befog Installation

Parts identification

• Backup Key

• Exterior Assembly

• Latch

• Latch Sewers

• Strike Sewers

• Strike

• Reinforcement Plate

• Mounting Plat
  

• Mounting Sewers

• Interior Assembly

• Sewers
  

• Battery Cover

• Drive-in Collar

• Reset Tool

Install exterior assembly

Route the cable below the latch

IMPORTANT: Bolt Must be in unlock Position note horizontal orientation of torque blade.

Route the cable through the hole in the mounting plate.

Secure the mounting plate with the Supplied Sewers.

Install interior assembly

Do not load batteries until lock is completely installed.

Remove the battery Cover.

Connect the cable and ensure tight cable connection.

Rotate the Thumb turn in vertical Position and insert the horizontal orientation of torque blade into the interior assembly lock switch

Secure the interior assembly with the Supplied Secure.

Tost the lock by rotating s : 1 see if the bolt can be extended and retracte.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>