TeeHO TE002 Fingerprint Door Lock Instruction Manual

TeeHO TE002 Fingerprint Door Lock

Installation Instructions

Parts List

Parts Identification

• Backup Key

• Exterior Assembly

• Latch

• Screws

• Strike

• Mounting Plate

• Screws
  

• Interior Assembly

• Screws
  

• Battery Cover

• Drive-In Collar
  

• Reset Tool

Prepare The Door And Check Dimensions

Measure to confirm that the hole in the door is 1 2-1/8″(54mm).

Measure to confirm that the backset is either 2-3/8″or 2-3/4″{60 or 70mm}.

Measure to con-firm that the hole in the door is 1 1″{25mm}.

Measure to confirm that door thickness is between 1-3/8″ and 2″ {35mm to 50mm}.

Choose Faceplate

OR

Is the slotted hole centered in the door hole?

Install Latch And Deadbolt

OR

IMPORTANT : Keep the latch in unlocked position before installation.

Install Exterior Assembly

Install Interior Assembly

Do not load batteries until lock is completely installed.

Remove the battery cover.

Connect the cable and ensure tight cable connection.

Rotate the Thumb turn in vertical position and insert the horizontal orientation of torque blade into the inside escutcheon.

Secure the interior assembly with the supplied screws.

Test the lock by rotating the thumb turn to see if the bolt can be extended and retracted smoothly.

Detect Left/right Hand Door Installation

IMPORTANT : This step is required and crucial for the lock after installation

While the door is open and unlock, load 3AA batteries into the interior assembly.

Press and hold the reset button on the interior assembly using the reset tool provided in package.

Load the last battery and keep holding the reset button for 3 seconds, until you hear the long sound of “BEEP”, the latch bolt will extend to learn the orientation of the door.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>