Hangzhou Qianwan Technology Co Ltd D1 GPS Tracker User Guide
- June 1, 2024
- Hangzhou Qianwan Technology Co Ltd
Table of Contents
Hangzhou Qianwan Technology Co Ltd D1 GPS Tracker
Instruction For Use
Step 1: Charging Guide
- Attach the tracker to the charger, When charging, the LED blinks, after full, the LED is steady on.
- Before the first use,please charge it for at least 2 hours.
- Do not use a fast charger to charge the device to avoid damaging the battery.
Step 2: Turning on the Tracker
-
Use the power button on the side of the device to turn on and off the tracker and check the LED status.
-
Follow the instructions on the DBDD GPS app to activate the tracker and find the 8-digit tracker ID.
Step 3: Attach the Tracker
-
Attach the tracker based on the width of your pet’s collar: a. If the collar width is 1.5 cm or less: Remove the rubber clip, slide the collar through the rectangular holes on both sides of the rubber clip, then re-attach the rubber clip to the tracker.
b. If the collar width is 1.6 cm or more: Open one side of the rubber clip on the tracker, place the collar between the rubber clip and the tracker, then close the rubber clip.
-
Replace the collar on your pet’s neck with the new one.
Scan code, read instructions.
tep 4: Using the Tracker
Download the DBDD GPS app to track your pet.
For more information, please visit www.dbdd.com/help
website.
Scan code Download APP
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm etween the radiator & your body.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>