TEEHO 20220331 Door Lock Instruction Manual
- June 13, 2024
- TeeHO
Table of Contents
TEEHO 20220331 Door Lock
Parts List
The details of part identification is shown on the following page
Prepare the door and check the dimensions
- Measure to confirm that the hole in the door is 2-1/8″ (54mm).
- Measure to confirm that the backset is either 2-3/8″ or 2-3/4″ (60 or 70mm).
- Measure to confirm that the hole in the door is 1″‘ (25mm).
- Measure to confirm that door thickness is between 1-3/8″ and 2″ (35mm to 50mm).
Choose faceplate
Is the slotted hole centered in the doorhole?
Install latch and deadbolt
IMPORTANT : Keep the latch in unlocked position before installation
INSTRUCTION
Parts identification
Install exterior assembly
- Route the cable below the latch.
- IMPORTANT : Bolt must be in unlocked position.
- Note the horizontal orientation of torque blade.
- Route the cable through the hole in the mounting plate.
- Secure the mounting plate with the supplied screws.
- Remove the battery cover.
- Connect the cable and ensure tight cable connection.
- Rotate the Thumb turn in vertical position and insert the horizontal orientation of torque blade into the inside escutcheon.
- Secure the interior assembly with the supplied screws.
- Test the lock by rotating the thumb turn to see if the bolt can be extended and retracted smoothly.
Detect left/right-hand door installation
IMPORTANT : This step is required and crucial for the lock after installation!
- While the door is open and unlock, load 3AA batteries into the interior assembly.
- Press and hold the reset button on the interior assembly using the reset tool provided in the package.
- Load the last battery and keep holding the reset button for 3 seconds, until you hear the long sound of “BEEP” , the latch bolt will extend to learn the orientation of the door.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>