VSYSTO MS02 2 Pack 10W LED Motorcycle Driving Lights User Manual

MS02 User Manual
V1.1

Connection Diagram

Power Cable

1. The red wire is connected to the positive pole of the motorcycle battery, the black wire is connected to the negative pole, and the yellow wire is connected to motorcycle ACC(The ACC power source is usually in the fuse box). If you can’t find your motorcycle ACC, please seek professional help.
2. After connecting the power cable, turn on the power supply of the motorcycle by turning the motorcycle key. The red indicator light of the wired remote control is always on, and the black box on the power cable shows the current voltage of the motorcycle. Pull out the key, the red light on the remote control goes off, indicating that the spotlights have been turned off.

Operation Method

1. When the power cable is connected, start the motorcycle power supply. The current motorcycle voltage will be displayed on the black box of the power cable, and the red indicator light of the remote control will always be on.
2. After the red indicator light is always on, long press the red button of the remote control for 3 seconds, and the spotlight will be on.
3. After the spotlight is on, short press the red button once, it will quickly enter the flash state. Short press the red button again to exit the flash state.
4. After the spotlight is on, short press the blue button once to switch the lighting mode. There are 4 lighting modes for spotlights, and each time you short press the blue button to switch one mode.
5. When the spotlight is on, long press the red button for 3 seconds to turn off the spotlight

Lighting Mode

The spotlight has four lighting modes:

1. High beam lamp, White light.
2. Low beam lamp, Yellow light.
3. High/Low beam lamp, White light and Yellow light are half on.
4. High/Low beam lamp, White light and Yellow light flash alternately.

Difference between Lights

1. The white light is the high beam lamp, its illumination is 1500LUX, the lumen is 2000LM, and the color temperature is 6000K.
2. The yellow light is the low beam lamp, its illumination is 1000LUX, the lumen is 1500LM, and the color temperature is 3000K.
3. The DC voltage range is 12-24V.

Troubleshooting

1. What if the spotlights don’t work?
   ①Please check whether the spotlights are plugged in properly. There is a black arrow on the spotlights interface, and the spotlights should be inserted in the direction of the arrow.
   ②Please check whether the red indicator of the remote controller is always on.

2. What if the colors of the two spotlights are different?
   In case of this phenomenon, just turn off the spotlights and wait for 5 minutes before turning on the spotlight.

3. If you have problems that cannot be solved, please contact customer service in time.

※Attention

1. Never connect to an unmatchable power adapter nor bend the power cable too hard in case of a short circuit.
2. Never disassemble nor attempt repair of this product. Doing so may damage the machine, cause electronic shock, and void your product warranty.
3. Due to software upgrades, resulting in some of the interface and functions and specifications are subject to change without prior notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>