suptek SPM201 Speaker Wall Mounts Instruction Manual

suptek SPM201 Speaker Wall Mounts

UNPACKING INSTRUCTIONS

• Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage.
• Check package contents against the supplied parts list in the next page to assure that all components wete received undamaged. Do not use damaged or defective parts.
• Carefully read all instructions before attempting installation.

IMPORTANT SAFETY INFORMATION

• before installation, and carefully follow all instructions contained herein. Use proper safety equipment during installation.
• Please call a qualified installation contractor for help if you don’t understand these directions or have any doubts about the safety of the installation.

Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby disclaims any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of this product.

Supplied parts list

(2) Wall Bracket-a

(2) Wall Bracket Cover-b

(2) Tilting End Cap-c

(2) M8x60mm Bolt-e

(2) Speaker Platform-d

(2) Plastic Washer-I

(2) MB Washer-g

(2) MB Nut-h

(10 )M4x12mm Wood Screw-i

(B) M6x45mm Lag Bolt-j

(B) Lag Bolt Washer-k

(B) M8x40mm Concrete Anchor-I

(1 ) Wrench-m

Tools Required|

• 3.8MM drill bit
• 8MM masonry bit

---|---

• Phillips Screwdriver
• carpenter’s level

WARNING

|

CAUTION!

---|---
This monitor desktop mount must be securely attached to the horizontal desk. If the mount is not properly installed it may fall, resulting in possible injury and/or damage.

Note : The mounting components and hardware supplied in this package are not designed for installations to walls with steel studs or to cinder block walls. If the hardware you need for your installation is not included, please consult your local hardware’s tore for proper mounting hardware for the application.

**Before you start

**

Optional Speaker Wire Management

Option A: Wires were concealed inside the wall

Option B: Wires were exposed outside the wall

Step 1

Brick Mount

Wood Mount

Step 2

Attaching the wall bracket cover and the speaker platform to wall bracket

Step 3

Placing speaker on the platform, adjust clamps to hold speaker in place

Step 4

OPTIONAL: secure speaker using M4x12 wood screws

Step 5

Adjusting the tilting angle and swing the speaker

We hope you never have the need, but if you do, our service is friendly and hassle-free.
: after-sales@suptekmount.com

Thank you for choosing our products!

Documents / Resources

| suptek SPM201 Speaker Wall Mounts [pdf] Instruction Manual
C1DIEGT7IML, SPM201, SPM201 Speaker Wall Mounts, SPM201, Speaker Wall Mounts, Wall Mounts, Mounts
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>