Suptek TS003-1 Universal Swivel Cantilever Table Top Pedestal TV Stand with Bracket User Manual
- May 15, 2024
- Suptek
Table of Contents
INSTALLATION MANUAL TS003-1
after-sales@suptekmount.com
UNPACKING INSTRUCTIONS
- Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage.
- Check package contents against the Supplied Parts List in the next page to assure that all components were received undamaged. Do not use damaged or defective parts.
- Carefully read all instructions before attempting installation
IMPORTANT SAFETY INFORMATION
Install and operate this device with care. Please read this instruction before
beginning the installation, and carefully follow allinstructions contained
herein. Use proper safety equipment during installation.
Please call a qualified installation contractor for help if you
- If you don’t understand these directions or have any doubls about the safety of the installation
- If you are uncertain about the nature of your wall, consult a qualified installation contractor.
Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby disclaim any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of this product.
Supplied Parts List
Step1 Connecting the Support Column to Tempered Glass
Step2 Mounting column, connector and head part
Step3 Mounting TV plate to the headstock Step4
Mounting the Monitor Brackets to a TV
First of all, make sure your TV mounting holes are compatible with size and
diameter of the provided Bolt I to r). Once you have determined the correct
diameter, please see the diagram below. Install the Boltinto the TV using the
correct Washer(s.t.u), and using the spacer(v,w) f necessary. Please make sure
the Monitor Brackets are vertically centered and level with each other.
Adjust the monitor brackets to different heights according to your viewing and
setup preference. Step5 Attaching TV To TV Plate
and Managing the Wires Step6 Attaching the Security
Steel Wire to the TV
If your TV is positioned close to the wall as shown in Diagram 5a, then a
steel wire can be attached for added security.
Attach two ends of the steel wire to the top two holes on the back of TV shown
in Diagram 5b. Step7 Attach the other end of the steel wire to the wall
according to your wall type, shown in Diagram 5c, 5d and Se.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>