suptek MA2720 TV Wall Mount Swivel Tilt Rotation User Manual

May 15, 2024
Suptek

suptek MA2720 TV Wall Mount Swivel Tilt Rotation User Manual

MA2720
after-sales-eu@suptekmount.com

FIG 1.JPG

UNPACKING INSTRUCTIONS

Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage. Check package contents against the Supplied Parts List in the next page to assure that all components were received undamaged. Do not use damaged or defective parts. Carefully read all instructions before attempting installation.

IMPORTANT SAFETY INFORMATION

Install and operate this device with care. Please read this instruction before beginning the installation, and carefully follow all instructions contained herein. Use proper safety equipment during installation. Please call a qualified installation contractor for help if you:

  • If you don’t understand these directions or have any doubts about the safety of the installation.
  • If you are uncertain about the nature of your wall, consult a qualified installation contractor. Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby disclaims any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of this product.

after-sales-eu@suptekmount.com

FIG 2.JPG

FIG 3.JPG

CAUTION!

This TV mount must be securely attached to the vertical wall. If the mount is not properly installed it may fall, resulting in possible injury and/or damage.

Note: The mounting kits and hardware provided in this package are not intended for installation on walls with steel studs or coal wall. If you do not include the hardware you need to install, please consult your local hardware store for the correct installation hardware for the device.

1. Install the Wall Plate to the Wall

Brick wall

FIG 4.JPG

Wood wall

FIG 5 Wood wall.JPG

2. Removal of the panel

3. Install the TV

FIG 6 Install the TV.JPG

FIG 7 Install the TV.JPG

6.The cable arrangement and the adjustment of the joint tightness

FIG 8 Install the TV.JPG

Hold the left and right sides of the TV, can adjust the rotation about the TV. If the rotation adjustment is too loose or too tight, use wrench (F) to tighten or loosen the nut on the figure shown to control the tightness of left and right rotation adjustment.

Insert the two wire clips (E) into the hole in the lower side of the square tube to complete the routing. Use the wrench (G) and wrench (F) to adjust the tightness of the joint.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals