turbionaire THEA50 Kitchen Hood Instruction Manual

: June 11, 2024
: turbionaire

Table of Contents

turbionaire THEA50 Kitchen Hood
Product Information
Product Usage Instructions
SAFETY INSTRUCTIONS
DIMENSIONS
INSTALLATION
Technical data
FUNCTIONS
- Gesture control
- STAINLESS STEEL SURFACE CLEANING
TROUBLESHOOTING
- HINTS ON DISPOSAL
Documents / Resources

turbionaire THEA50 Kitchen Hood

turbionaire-THEA50-Kitchen-Hood-PRODUCT

Product Information

The THEA 50/75 is a kitchen hood or hota de bucatarie that can be used in extraction or recirculation mode. It comes with elastic pins on both sides to fit into a cabinet and has a metal grease filter that can be removed for cleaning. The product has a motor capacity, maximum cooker hood airflow, and an electric power input that is suitable for use with gas, oil, wood, or coal- fired heaters, tankless water heaters, and water heaters. The product has a sound power level and energy efficiency class rating. The dimensions of the product are as follows:

THEA 50 – Product Code TH50RCB, TH50RC: 520.46 x 295.6 x 169.2 mm
THEA 75 – Product Code TH75RCB, TH75RC: 520 x 430 x 299.4 mm

Product Usage Instructions

Before installation, ensure that the negative pressure in the room does not exceed 4 Pa (4 x 10-5 Bar) when the range hood and appliance supplied with energy other than electricity are simultaneously in operation.

Installation Steps

1. Saw an opening in the wall cabinet under which the hood is to

be fitted. Use the following dimensions (mm) as a guide:

1. Insert the range hood into the cabinet, ensuring that the
  elastic pins on both sides are fixed on the cabinet.
1. Remove the metal grease filter.
Adjust the screws until the flanges of both sides are fixed on the cabinet as shown in Image 5.
1. Reinstall the metal grease filter and complete the installation as shown in Image 7.
1. Install the duct adaptor, check valve (Image 8), suction pipe (Image 9), and electrical connection (Image 10).
Install the carbon filter (not included) with the product code TCF1 for THEA 50/50 BLACK and THEA.

Note: Do not connect the power cable until the installation is complete. Get a second person to help you with the installation.

SAFETY INSTRUCTIONS

Thank you for purchasing this cooker hood. Please read the instruction manual carefully before you use the cooker hood, and keep it in a safe place.
The installation work must be carried out by a qualified electrician or competent person. Before you use the cooker hood, make sure that the voltage (V) and the frequency (Hz) indicated on the cooker hood are exactly the same as the voltage (V) and the frequency (Hz) in your home.
The manufacturer and the agent will not bear any responsibility for the damage caused by inappropriate installation and usage.
Never let children operate the cooker hood.
The cooker hood is for home use only. It is not suitable for barbecues, Roast shop and commercial purposes.
The cooker hood and its filter mesh should be cleaned regularly in order to keep it in good working order.
Before cleaning, switch the power off at the main supply.
Clean the cooker hood according to the instruction manual and keep the cooker hood from the danger of burning.
Prohibit putting the cooker hood by fire.
If there is any fault with the appliance, please call the service department to request a service engineer.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
The instructions shall state the substance of the following: there shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).
Do not flambé under the range hood. Accessible parts may become hot when used with cooking appliances.

Important Hints on Installation

The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).
Regulations concerning the discharge of air have to be fulfilled.

Important notes about the extraction mode

WARNING

Risk of poisoning from exhaust gases sucked back. Never operate the device in extraction mode simultaneously with an open flue appliance when there is not adequate airflow guaranteed.
Open flue combustion equipment (for example, gas, oil, wood or coal-fired heaters, tankless water heaters, water heaters) pulls combustion air from the room and runs it through an exhaust pipe or chimney to the outside. In the extraction mode, indoor air is removed from the kitchen and the adjacent rooms – without suffi cient air intake this creates a vacuum. Toxic gases from the chimney or extraction fl ue can thereby be sucked back into the living spaces.
Always ensure that a suffi cient supply of fresh air is guaranteed and that the air can circulate.
An air supply/extractor box alone does not ensure compliance with the limit value.
Safe operation is only possible when the negative pressure in the room where the appliance is located does not exceed 4 Pa (0.04 mbar). This can be achieved when the air required for combustion can fl ow through openings that are not closable, for example in doors, windows, in conjunction with an air supply/ extractor box or through other technical measures. In any case, consult a qualifi ed chimney sweep who can assess the entire ventilation of your house and propose appropriate measures for adequate ventilation.
If the hood is used exclusively in the recirculation mode, unrestricted operation is possible.

WARNING

Fire hazard from flying sparks. Only install equipment on a fire place for solid fuels (for example, wood or coal), if a closed, non-removable cover is available.

DIMENSIONS

Model No.: THEA – Product Code TH50RCB，TH50RC

THEA 75 – Product Code TH75RCB, TH75RC turbionaire-THEA50-Kitchen-Hood-
FIG-2

INSTALLATION

Note: When the range hood and appliance supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must be not exceed 4 Pa (4 x10-5 Bar).

Required minimum distance hood to
Ceramic-glass rings/hotplates: 65 cm
Gas cooker: 75 cm
Coal/oil/stove wood firing 85 cm

Installation Steps
Note: Do not connect the power cable until the installation is complete! Get a second person to help you with the installation.

Saw an opening in the wall cabinet under which the hood is to be fitted. Use the following dimensions (mm) as a guide:
- HOLE MEASUREMENTS FOR INSTALLATION (mm)
2. Insert the range hood into the cabinet. Please make sure the elastic pins on both sides are fixed on the cabinet.
Remove the metal grease filter
Adjust the screws 1. 2 .3 .4 . until the flanges of both sides are fixed on the cabinet as the Image 5
Reinstall the matel grease filter (Image 6), and complete the installation (Image 7)
The size (mm) of the duct.
Installation of check valve (Image 8), suction pipe, (Image 9), and electrical connection (Image 10)
- Model No.: THEA 50 – Product Code TH50RCB，TH50RC
Installation of the carbon filter – CODE: TCF1 (not included)
- Model No. : THEA 50/ 50 BLACK – product Code TH50RCB, TH50RC

THEA – Product Code TH50RCB, TH50RC

Technical data

| Value| Unit
---|---|---
Motor capacity| 800| m³/h
Maximum cooker hood airflow – boost| 607| m³/h
Cooker hood airflow at working point – high

Cooker hood airflow at working point – low

| 542| m³/h
344| m³/h
Electric power input| 124| W
Nominal power of the lighting system| 4| W
Sound power level – boost Sound power level – high

Sound power level – low

| 67| dB
65| dB
55| dB
Energy Efficiency class| A+|
Annual Energy Consumption| 23.4| kWh/a
Connection diameter – Minimum/ Optimum| 120/150| mm

THEA 75 – Product Code TH75RCB, TH75RC

| Value| Unit
---|---|---
Motor capacity| 800| m³/h
Maximum air flow – Boost| 692| m³/h
Cooker hood airflow at working point – high

Cooker hood airflow at working point – low

| 613| m³/h
313| m³/h
Electric power input| 125| W
Nominal power of the lighting system| 5| W
Sound power level – boost Sound power level – high

Sound power level – low

| 66| dB
65| dB
50| dB
Energy Efficiency class| A++|
Annual Energy Consumption| 27.2| kWh/a
Connection diameter – Minimum/ Optimum| 120/150| mm

THE 50/ 75

FUNCTIONS

ON/ OFF Key – turning ON/ OFF the Fan
Speed plus key – For increasing the speed of the fan. Long press this icon for booster setting will go back to high speed after operating for 5 minutes.
Speed decrease key – For decreasing the speed of the fan.
Light Key – turning ON/ OFF the light
Digital Display – Fan speed display: 1″ for Low speed, “2” for Medium speed, “3” for High speed, “B” for Booster speed, C” for air cleaning function.
Quick timer: Press & simultaneously for 1 second. The digital display flashes & the countdown starts for 5 minutes. After 5 minutes, the motor & the light will turn off automaticaly & the Buzzer sound will keep buzzing for 5 seconds if there is no other operations, the buzzer sound can be stopped by depressing any button during the buzzing. If need to stop this function during the countdown, press & simultaneously for 1 second again.

Air cleaning function

In the standby state, long press the key for 3 seconds to enter the air cleaning function.
This function automatically shuts down after 5 minutes of low-speed operation. After 55 minutes of stop, it automatically runs again for 5 minutes and then stops again for 55 minutes. “C” is displayed on the display screen during low-speed operation. After this function is started, it can only be turned off by pressing the on key again for 1 second, without affecting other normal switch operations (the key blinks when entering the air cleaning function).

How to match the remote control

In the standby state, long press the button for 3 seconds to enter the remote control matching state, and the indicator light keeps flashing.
In the matching state, press the remote control button and a beep sound will be heard, the remote is successfully matched. If no operation is performed or the match fails after 15 seconds, the system returns to the standby state.

How to use the remote control

ON/ OFF Key – used for turning on/off the fan.
Speed plus key – For increasing the speed of the fan; Long press this icon for the Booster setting, will go back to high speed after operating for 5 minutes.
Speed decrease key – For decreasing the speed of the fan.
Light key – used for turning on/off the light

Gesture control

This function is available if the unit is in standby mode. Motion sensors are activated by passing the hand from left to right or vice versa through the control panel.

Moving the hand from left to right increases the speed level. From boost mode, the same movement causes the return to minimum speed.
Passing the hand from right to left, a function available only when the unit’s motor is on, causes it to enter Quick Timer mode, after which it will stop after 5 minutes. From the Quick

In timer mode, the same movement causes the unit to stop immediately.
The speed level set as a result of the gesture control will be permanently displayed on the display. In Quick Timer mode, the speed level will be displayed intermittently.

STAINLESS STEEL SURFACE CLEANING

To avoid damaging the stainless steel surface of your appliance

Always clean with:

Soft cloths, distilled or filtered water, as well as detergents specially made for stainless steel.

Do not clean with:

Abrasive materials, cleaning powders, bleach, and other chlorine-based products, ammonia-containing glass cleaners, tap water especially if it tends to be hard water, oven cleaners.
Damage to stainless steel surfaces due to the use of improper cleaning substances is not covered by the warranty.

TROUBLESHOOTING

Fault	Cause	Solution
Light on, but fan does not work	The fan blade is jammed.	Switch of the unit

and repair by qualified service personnel only.
The motor is damaged.
Both light and fan do not work| light bulb burn.| Replace the bulb with correct rating.
Power cord looses.| Plug in to the power supply again.
Serious Vibration of the unit| The fan blade is damaged.| Switch of the unit and repair by qualified service personnel only.
The fan motor is not fixed tightly.
The unit is not hung pro-perly on the bracket.| Take down the unit and check whether the bracket is in proper location.
Suction performance not good| Too long distance between the unit and the cooking plane| Readjust the distance to 65-75cm

HINTS ON DISPOSAL

According to the European waste regulation 2012/19/EU, this symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead, it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling this product, please contact your local council or your household waste disposal service.