FELIXBATH Zexzen LED Bathroom Faucet Chrome Installation Guide
- June 1, 2024
- FELIXBATH
Table of Contents
Installation Guide
Tools you will need
1/2″ FIP Hose Rags
Sealant Tape Stainless (Non-Staining) Plumbers Putty
CRITICAL DIMENSIONS
Note: Style may vary by model
Before Installation
A. Make sure you have all necessary parts by checking the diagram and parts list.
B. Turn off the hot and cold water supply at the angle and turn on the old faucet to release any built up pressure. Remove existing faucet. Clean sink or counter top preparation for new faucet.
C. Shut off angle stops.
D. Pre-drilled hole size requirement:1-3/8″ (min)-1-1/2″ (max)
Max counter top thickness without deck plate:1-1/2″ (1 hole install)
Max counter top thickness with deck plate:1″ (1 ,2 or 3 hole install)
A: 1/16″ (1 mm) min
1-1/2″ (38 mm) max
B: Φ 1-3/8″ (35mm) min
Φ 1-1/2″ (38 mm) max
A: 1/16″ (1 mm) min
1″ (25. 4 mm) max
B: Φ 1-3/8″ (35mm) min
Φ 1-1/2″ (38 mm) max
(1)
Place spout in center hole of sink. Assembly washer and tighten the lock nut to it. Connect the T-valve to the spout body using the wrench.
(2)
Place the handle body through right/left hole. (Left is red, right is blue).
(3)
Assemble the rubber washer, washer and tighten with lock nut. Use hoses to connect spout to 2 handle control with fast connector.
(4)
Connect water supply tube to valve body and tighten with lock nut. Do not allow the water supply brass tube to twist. Use two wrenches, as shown in the diagram, tighten the water hose
(5)
- HOT
- COLD
Attach two flexible hoses to two water supplies.