SUPERATV IN-RF-TR-800SX4 Tracker 800SX Crew Aluminum Roof Instruction Manual
- June 15, 2024
- SUPERATV
Table of Contents
SUPERATV IN-RF-TR-800SX4 Tracker 800SX Crew Aluminum Roof
- SuperATV does not recommend keeping Roof installed while transporting on an open air trailer. Remove or secure with straps.
- Do not discard packaging until product has been successfully installed.
Liability Statement
SuperATV’s® products are designed to best fit user’s ATV/UTV under stock
conditions
Adding, modifying, or fabricating any factory or aftermarket parts will void
any warranty provided by SuperATV® and is not recommended. SuperATV’s®
products could interfere with other aftermarket accessories. If user has
aftermarket products on machine, contact SuperATV® to verify that they will
work together. Although SuperATV® has thousands of satisfied customers, user
should be aware that installing lift kits, long travel, or suspension kits,
tires, etc. will change the ride of machine and may increase maintenance and
part wear. Operating any off-road machine while, or after, consuming alcohol
and/or drugs increases risk of bodily harm or death. No warranty or
representation is made as to this product’s ability to protect user from
severe injury or death. SuperATV® urges operators and occupants to wear a
helmet and appropriate riding gear at all times.
By purchasing and installing SuperATV® products, user agrees that should damages occur, SuperATV® will not be held responsible for loss of time, use, labor fees, replacement parts, or freight charges. SuperATV®, nor any 3rd party, will not be held responsible for any direct, indirect, incidental, special, or consequential damages that result from any product purchased from SuperATV®. The total liability of seller to user for all damages, losses, and causes of action, if any, shall not exceed the total purchase price paid for the product that gave rise to the claim. SuperATV® will warranty only parts provided by SuperATV®. Any damage or problems with OEM housings, bearings, seals, or other manufacturers’ products will not be covered by SuperATV®. SuperATV® parts and products are not warrantied if item was not installed properly, misused, or modified.
Installing, adding, modifying, or fabricating any factory or aftermarket product to your ATV/UTV may violate certain local, state, and federal laws. Be advised that laws vary depending on town, city, county, state, etc. Use of certain products on public streets, roads, or highways may be in violation law. The Buyer is solely and exclusively legally and personally responsible for any violation of the law by the installation or use of the product. You must abide by all local, state, and federal laws, including but not limited to vehicle safety, traffic laws, and ordinances. It is your responsibility to know the laws and how they apply to you.
The Buyer is responsible to fully understand the capability and limitations of his/her vehicle according to manufacturer specifications, warnings and instructions and agrees to hold SuperATV® harmless from any damage resulting from failure to adhere to such specifications, warnings and/ or instructions. The Buyer is also responsible to obey all applicable federal, state, and local laws and ordinances when operating his/her vehicle while using this product, and the Buyer agrees to hold SuperATV® harmless from any violation thereof.
- Install hardware shown to rear of Cage. Repeat for passenger side.
- Install Gasket to Rear. Gasket to run length of Rear.
- Install Gasket to Front. Gasket to run length of Front and cover mounting holes.
- Use a punch to make holes in previously installed Gasket.
- Join Front , Middle, and Rear with hardware shown; tighten.
- Secure Front to Frame with hardware shown; do not tighten.
- Secure Roof to U-Clips with hardware shown; do not tighten. Repeat for passenger side.
- Install Clamps around Cage in locations shown. Secure Roof to Clamps with hardware shown; do not tighten.
- Align Roof to machine and tighten all hardware.
Align Roof to machine and tighten all hardware.