HONDA GL1800-D-DA Custom Seat Instruction Manual
- June 13, 2024
- Honda
Table of Contents
INSTALLATION INSTRUCTIONS
Accessory| Application| Publication No.
MII 16426
---|---|---
CUSTOM SEAT
P/N 08R76-MKC-A00| GL1800/D/DA| Issue Date
January 2018
Honda Dealer: Please give a copy of these instructions to your customer.
PARTS LIST
| No. | Description | Qty |
|---|---|---|
| 1 | Custom seat | 1 |
| 2 | Installation Instructions URL | 1 |
TORQUE CHART
Refer to the Service Manual for the torque values of the removed parts.
INSTALLATION
CAUTION
- To prevent burns, allow the engine, exhaust system, radiator, etc., to cool before installing the accessory.
NOTE:
- Disconnect the negative (-) cable from the battery before installing this accessory.
- The clock memory will be erased when you disconnect the battery. Reset the memories after reconnecting the battery.
- Reinstall the removed parts on the motorcycle and make sure that the wires and harnesses are not pinched.
-
Open the left saddlebag lid as shown.
• Repeat on the right side.
-
Remove the left side cover as shown, and disconnect the negative (-) cable of the battery.
-
Remove the right side cover in the same manner as the left side.
-
Remove the seat as shown.
• Disconnect the connector for GL1800/D/DA.
-
Install the custom seat in the reverse order of removal.
-
Install the motorcycle’s parts in the reverse order of removal.
• Confirm that any wire harness is not caught or too tight.
© 2018 American Honda Motor Co., Inc. – All Rights Reserved.
87972-MKC-A000.indd